Xerox XA7-19i manual Osd Menu, Using the OSD Menu, Exit

Page 15

OSD Menu

3 OSD MENU

The OSD (On Screen Display) Menu allows the user to adjust various settings and options by following the steps below.

1Press the MENU button to display the OSD.

2Press the UP or DOWN button to highlight the desired icon.

3Press the MENU button to activate the highlighted icon.

4Press the UP or DOWN button to change the value of the selected item.

5Select the EXIT icon to exit the OSD.

6Repeat steps 1 through 5 to make further adjustments. All changes are stored immediately.

14	Xerox© LCD Monitor User’s Manual

Image 15

Contents Page 2004 by Xerox Corporation. All rights reserved Introduction Table of ContentsInstallation Federal Communications Commission FCC StatementENGLISH Federal Communications Commission FCC StatementWarnings Important Safety InstructionsDo not touch the power cord and antenna cable during lightning d. The product has been dropped or damaged a. The power cord or plug is damagedb. Liquid is spilled into the product c. An object falls onto or into the product1 Introduction FeaturesPower cord specification H05 VV-F 3G 0.75mm2 Package Contents2 DOWN/UP 5 POWERFront View and Controls 1 MENUInstalling Your LCD Monitor 2 Installation Connecting Your LCD Monitor to a ComputerMethod 1 Analog D-SUB Connection 2 Connect to the DVI port Method 2 DigitalDVI ConnectionUsing Your LCD Monitor 5o 20oPOWER/ button Using the OSD Menu 3 OSD MENUEXIT Contrast PhaseThe OSD Options BrightnessWARM ColorSelect User Mode COOLLanguage ResetDot X Line Preset Mode Timing ChartVideo signal IBM PC/AT 4 Technical InformationDESCRIPTION DVI Connector PIN AssignmentSCL FOR DDC D-SUB Connector PIN AssignmentDESCRIPTION Red Green Blue Ground Self Test Red Ground Green Ground Blue Ground 5 VDC Ground Ground SDA FOR DDC H. Sync V. SyncExample Plug and PlayVisual Inspection Permanently unlit or lit pixelsPoor picture or abnormal picture TroubleshootingMonitor will not turn on No picture