3
Connections
Rear Panel
Figure 3-1 shows where all of the rear panel connections to the mainframe are made.
Figure 3-1. Rear Panel Connections
Module Connections
Wire connections to the modules are made using a separate module connector that is supplied with each module. After the module connector has been wired, it simply attaches to the back of the mainframe. You can attach the module connector to the mainframe either before or after the module is installed. Instructions for wiring and attaching the connector are provided with each module.
Note | Install the module connectors from left to right on the back of the mainframe. This makes it easier to |
| access the screws that attach the connectors to the mainframe. |
|
|
| Connections 21 |