Belkin F1DA116Z, F1DA104Z BANK-DIP-Switch Configuration Chart, How to Assign a Bank Address

Installation

How to Assign a BANK Address

All PRO3 KVM Switches feature a “BANK DIP” switch. The “BANK DIP” switch is used to assign the proper BANK address to each PRO3 KVM Switch.

•For a single-unit configuration, set the “BANK DIP” switch on the PRO3 KVM Switch to the “primary” (BANK address 00) setting. This is the factory default setting.

•For a multi-unit configuration, the “BANK DIP” switch on the primary KVM switch must be set to “BANK address 00”. Each secondary unit must be set to a unique BANK address (from 01 through 15). Refer to the chart below for “BANK DIP” switch settings.

BANK-DIP-Switch Configuration Chart

DIP SWITCH#						BANK
						ADDRESS
1	2	3	4	5	6
ON	ON	ON	ON	ON	ON	BANK	0	PRIMARY (default)
ON	ON	OFF	ON	ON	ON	BANK	1	SECONDARY
ON	ON	ON	OFF	ON	ON	BANK	2	SECONDARY
ON	ON	OFF	OFF	ON	ON	BANK	3	SECONDARY
ON	ON	ON	ON	OFF	ON	BANK	4	SECONDARY
ON	ON	OFF	ON	OFF	ON	BANK	5	SECONDARY
ON	ON	ON	OFF	OFF	ON	BANK	6	SECONDARY
ON	ON	OFF	OFF	OFF	ON	BANK	7	SECONDARY
ON	ON	ON	ON	ON	OFF	BANK	8	SECONDARY
ON	ON	OFF	ON	ON	OFF	BANK	9	SECONDARY
ON	ON	ON	OFF	ON	OFF	BANK	10	SECONDARY
ON	ON	OFF	OFF	ON	OFF	BANK	11	SECONDARY
ON	ON	ON	ON	OFF	OFF	BANK	12	SECONDARY
ON	ON	OFF	ON	OFF	OFF	BANK	13	SECONDARY
ON	ON	ON	OFF	OFF	OFF	BANK	14	SECONDARY
ON	ON	OFF	OFF	OFF	OFF	BANK	15	SECONDARY

ON = Up Position, OFF = Down Position

Example: Four 8-Port PRO3 KVM Switches (F1DA108Z) are daisy-chained together to manage up to 32 servers. The DIP switch on the primary KVM switch is set to “BANK 00” (factory default) and the secondary units are each set to a unique BANK (between 01 and 03).

1

2

3

4

5

6

7

8

section

21