Belkin F1DE101G user manual Firewall, IP access control parameters

Page 26

SECURITY

Firewall

IP access control parameters

Parameter	Description

Enable Firewall	Enables access control based on IP source addresses.

Default Policy	This option controls arriving IP packets that don’t match any of the
	configured rules. They can be accepted or dropped.
	Note: If you set this to DROP and you have no ACCEPT rules configured, access
	to the Web over LAN is disabled. To enable access again, you can change the
	security settings via modem or ISDN dial-in or by temporarily disabling IP
	access control with the initial configuration procedure.

Rule Number	This should contain the number of a rule for which the following commands
	will apply. This field will be ignored, in case of appending a new rule.

IP/Mask	Specifies the IP address or IP address range for which the rule applies.
	Examples (the number concatenated to an IP address with a ‘/’ is the
	number of valid bits that will be used of the given IP address):
	192.168.1.22 or 192.168.1.22/32 matches the IP address 192.168.1.22
	192.168.1.0/24 matches all IP packets with source addresses from
	192.168.1.0 to 192.168.1.255
	0.0.0.0/0 matches any IP packet

Firewall Settings Menu

24

Image 26

Contents OmniView Table of Contents Package Contents IntroductionFeature Overview Software Requirements Equipment RequirementsHardware Requirements Specifications Link/Activity LED Ripc DiagramsConnection LED Serial 02 Port LAN PortInstallation Hardware InstallationSerial Power Reset Connecting the Computer or KVM USB Powering Up the Ripc Initial Network Configuration Connecting the Ripc to the Network Sync Remote AccessVideo settings Configuration via serial Prerequisites Following interfaces are supportedLog Into the Ripc For a secure connection, you must enterMain Screen Control Host Remote Access Log Out from the RipcAuto Adjust Port by sending the appropriate hot key to the KVM switchMonitor mode is currently active Control Description OptionsRipc Mouse Synchronization Remote Access OptionsPower Management Unit Sync DetectLimitations of the Mouse Synchronization Single Direct Mouse ModeBadly Adjusted Picture Special Mouse DriverVideo Settings Https Port Ports & ProtocolsForce Https Http PortIP access control parameters FirewallCertificate Management SSL Certificate RequestCertificate Request Required Information See Figure belowSettings & Configuration Network SSL Certificate Signing RequestNetwork Settings Menu Remote Access SettingsRemote Access Options Table Users & Passwords Delete User Description Users & Passwords TableAdd User Modify UserSerial Port Modem SettingsSerial Port Settings Table Modem Options Table Keyboard/Mouse Settings Keyboard/Mouse Options TableKVM Switches Firmware Syntax to define a new hot key is as followsUpdate Firmware Ripc Video ModesHot Key Table TildeGlossary Does the Ripc put any strain on the servers? Does the Ripc work with non-Belkin KVM switches?What operating systems does the Ripc support? Remote mouse doesn’t work or is not synchronous Login failsRemote Access window can’t connect to the Ripc Video quality is bad or the picture is grainyCE Declaration of Conformity Belkin Corporation Limited Five-Year Product WarrantyFCC Statement P74238-A