Belkin F1DE101G user manual SSL Certificate Signing Request, Settings & Configuration Network

Page 29

SECURITY

SSL Certificate Signing Request

Note: If you destroy the CSR on the RIPC, there is no way to get it back! If you delete it by mistake, repeat the three steps.

Settings & Configuration Network

	Network Settings Parameters

Parameter	Description

IP address	IP address in the usual dot notation.

Subnet mask	The net mask of the local network.

Gateway IP address	The gateway of the network.

1. DNS Server IP	IP address of the primary Domain Name Server in dot notation. This
	option may be left empty, however, the RIPC won’t be able to perform
	name resolution.

2. DNS Server IP	IP address of the secondary Domain Name Server in dot notation. It
	will be used in case the Primary DNS Server can’t be contacted.

Enable Power	If this option is enabled, access over the Power Management Unit is
Management Unit	possible. For this reason, to ensure the best level of security, we
	recommend you disable this parameter.

(Note: Changing the network settings of the RIPC might result in lost connections. If you change the settings remotely, be sure all the values are correct so that you will still be able to access the RIPC.)

27

Image 29

Contents OmniView Table of Contents Introduction Package ContentsFeature Overview Software Requirements Equipment RequirementsHardware Requirements Specifications Connection LED Ripc DiagramsLink/Activity LED Serial 02 Port LAN PortHardware Installation InstallationSerial Power Reset Connecting the Computer or KVM USB Powering Up the Ripc Initial Network Configuration Connecting the Ripc to the Network Sync Remote AccessVideo settings Configuration via serial Following interfaces are supported PrerequisitesFor a secure connection, you must enter Log Into the RipcMain Screen Log Out from the Ripc Control Host Remote AccessMonitor mode is currently active Port by sending the appropriate hot key to the KVM switchAuto Adjust Control Description OptionsPower Management Unit Remote Access OptionsRipc Mouse Synchronization Sync DetectBadly Adjusted Picture Single Direct Mouse ModeLimitations of the Mouse Synchronization Special Mouse DriverVideo Settings Force Https Ports & ProtocolsHttps Port Http PortFirewall IP access control parametersSSL Certificate Request Certificate ManagementSee Figure below Certificate Request Required InformationSSL Certificate Signing Request Settings & Configuration NetworkRemote Access Settings Network Settings MenuRemote Access Options Table Users & Passwords Add User Description Users & Passwords TableDelete User Modify UserSerial Port Modem SettingsSerial Port Settings Table Modem Options Table Keyboard/Mouse Options Table Keyboard/Mouse SettingsKVM Switches Syntax to define a new hot key is as follows FirmwareRipc Video Modes Update FirmwareTilde Hot Key TableGlossary Does the Ripc put any strain on the servers? Does the Ripc work with non-Belkin KVM switches?What operating systems does the Ripc support? Remote Access window can’t connect to the Ripc Login failsRemote mouse doesn’t work or is not synchronous Video quality is bad or the picture is grainyCE Declaration of Conformity Belkin Corporation Limited Five-Year Product WarrantyFCC Statement P74238-A