Belkin F1DE101G user manual Serial Power Reset

Page 9

INSTALLATION

1.Power down your server or KVM Switch.

2.Connect your PS/2 type keyboard and mouse to the appropriate PS/2 “Console” ports.

Serial 02

	power
Serial 01	reset	LAN

consoleCPU/KVM

1

2

3

4

5

6

7

8

9

0

= / -

7 8 9

+

4 5 6

1	2	3
0

3.Take the video cable that is attached to your VGA monitor and connect it to the “Console” port.

7

Image 9

Contents OmniView Table of Contents Introduction Package ContentsFeature Overview Equipment Requirements Hardware RequirementsSoftware Requirements Specifications Connection LED Ripc DiagramsLink/Activity LED Serial 02 Port LAN PortHardware Installation InstallationSerial Power Reset Connecting the Computer or KVM USB Powering Up the Ripc Initial Network Configuration Connecting the Ripc to the Network Remote Access Video settingsSync Configuration via serial Following interfaces are supported PrerequisitesFor a secure connection, you must enter Log Into the RipcMain Screen Log Out from the Ripc Control Host Remote AccessMonitor mode is currently active Port by sending the appropriate hot key to the KVM switchAuto Adjust Control Description OptionsPower Management Unit Remote Access OptionsRipc Mouse Synchronization Sync DetectBadly Adjusted Picture Single Direct Mouse ModeLimitations of the Mouse Synchronization Special Mouse DriverVideo Settings Force Https Ports & ProtocolsHttps Port Http PortFirewall IP access control parametersSSL Certificate Request Certificate ManagementSee Figure below Certificate Request Required InformationSSL Certificate Signing Request Settings & Configuration NetworkRemote Access Settings Network Settings MenuRemote Access Options Table Users & Passwords Add User Description Users & Passwords TableDelete User Modify UserModem Settings Serial Port Settings TableSerial Port Modem Options Table Keyboard/Mouse Options Table Keyboard/Mouse SettingsKVM Switches Syntax to define a new hot key is as follows FirmwareRipc Video Modes Update FirmwareTilde Hot Key TableGlossary Does the Ripc work with non-Belkin KVM switches? What operating systems does the Ripc support?Does the Ripc put any strain on the servers? Remote Access window can’t connect to the Ripc Login failsRemote mouse doesn’t work or is not synchronous Video quality is bad or the picture is grainyBelkin Corporation Limited Five-Year Product Warranty FCC StatementCE Declaration of Conformity P74238-A