Belkin OmniView manual Local Video Port Settings Enable Local Video Port, Custom Video Modes

4-4 KVM Settings		Menu Options
Video
1
2			2a
3			2b
				3b
	3a
	3c			3d
	3e			3f
				3g

To set the options (see below), click the “Apply” button.

1.Local Video Port Settings

Enable Local Video Port

This option monitors the local video output of the RIPM, and indicates whether it is active and passing through the incoming signal from the host system.

2.Miscellaneous Video Settings

2a. Noise Filter

This feature defines how the RIPM reacts to small changes in the video-input signal. A large filter setting needs less network traffic and leads to a faster video display, but small changes in some display regions may not be recognized immediately. A small filter displays all changes instantly but may lead to a constant amount of network traffic even if the display content is not really changing (depending on the quality of the video-input signal).

2b. Force Composite Sync (Required for Sun Computers)

To support signal transmission from a Sun machine, enable this option. If this function is not enabled, the picture of the Remote Console will not be visible.

3.Custom Video Modes

The maximum number of custom video resolutions is four.

The “Custom Modes Handling” option lets you disable custom modes (“Off”), or set standard or exclusive video resolutions (“Only”). A final option (“Additional”) allows you to force a special video mode for the RIPM. To change the parameters for custom video mode, choose the appropriate number from the selection box and press the “Update” button. You will be required to provide some additional information so that the video mode can be correctly recognized:

Warning: The “Host Monitor Settings” option is for advanced users only. Using it incorrectly can damage video-transmission performance. Please be sure that you understand the feature thoroughly before attempting to adjust the Host Monitor Settings.

1

2

3

4

5

6

section

50