Star Micronics DP8340R user manual Replace the Printer Cover

Page 15

4-3-2. Roll Paper Installation (When using the optional Printer Cover 8340R)

When installing roll paper with the optional “Ptinter Cover 8340R”, please use the following procedure.

(1)Turn power off, lift the Printer Cover up and remove it.

Note: Be careful not to touch the print head immediately after printing because it can get very hot.

(2)Insert paper into the printer, and feed the paper so it extends 3 inches or more above the top surface of the printer.

(3)Insert the paper into the slot in the “Printer Cover 8340R”.

(4)Install the “Printer Cover 8340R” on the printer.

Figure 4-6. Replace the Printer Cover

Figure 4-7. Printer Cover 8340R

– 11 –

Image 15

Contents DOT Matrix Printer DP8340R Series Serial Interface Trademark acknowledgments Table of Contents RS-232C Current Loop Setting of the DIP Switches DIP-SW Model Name Notation OutlineUnpacking Unpacking and InstallationInstallation of Paper Holders Installation of Paper Holders and Re-Roll Prevention GuardHandling Notes Installation of Re-Roll PreventionPart Identification and Nomenclature Power Supply UnitPrinter Front View PrinterPart Functional Description Installation of Ink Ribbon Installation of INK Ribbon and PaperRemoval of Ink Ribbon Installation of Ink RibbonFor Roll Paper Paper InsertionReplace the Printer Cover Roll Paper Removal Validation Option InstallationControl Codes ESC F Code ESC @ 1BH 40H Printer initialization ESC P Remarks Character Code List General Specifications Input Output AC 100 240 DC 12.0 V± 5% 47Hz 63 Hz Roll Paper and Print Area External Dimensions Printer Interface Circuit Interface SpecificationsDIP-SW2 Setting of the DIP SwitchesError Condition Alarm Mode Connectors and SignalsInterface Connections Cable Connection Peripheral Unit Drive CircuitPeripheral Drive Circuit Control CodesInterface for Model DP8340RD D-SUB 25 PIN Connector Current Loop RS-232CSetting of the DIP Switches Jumper Setting Setting of JumperRemoval of the Bottom Cover CTS D-Sub 25 Pin Connector Peripheral Unit Drive Circuit Peripheral Drive Circuit DTR Mode 1 Block Machine ErrorPaper Empty ON/X-OFF Mode Parity Framing ErrorSTX-ETX Mode STX-ETX Mode Flow Diagram Character Code List Page International Character Sets When Power is Supplied by the User Other parameters may be determined by user