Star Micronics DP8340R user manual D-Sub 25 Pin Connector

Page 39

Figure 8-5. D-Sub 25 Pin Connector

*1 Error Condition Alarm Mode

If an error condition is detected during operation, the printer will stop printing and cause the FAULT signal to go MARK. All solenoides & motors will be de-energized. It is necessary to turn the printer power off and on again in order to recover from the alarm mode.

This printer can detect the following error coditions:

a.Motor Lock

b.Defective timing detector

c.Micro-proccessor out of program sequence

8-6. Interface Connections

For interface connections, refer to the instructions for interface of the host computer. The following gives one basic example of connections.

Figure 8-6. Interface Connections

with D-Sub 25 Pin Connector to IBM PC

D

TYPE

ONLY

– 35 –

Image 39

Contents DOT Matrix Printer DP8340R Series Serial Interface Trademark acknowledgments Table of Contents RS-232C Current Loop Setting of the DIP Switches DIP-SW Model Name Notation OutlineUnpacking Unpacking and InstallationInstallation of Paper Holders Installation of Paper Holders and Re-Roll Prevention GuardHandling Notes Installation of Re-Roll PreventionPart Identification and Nomenclature Power Supply UnitPrinter Front View PrinterPart Functional Description Installation of Ink Ribbon Installation of INK Ribbon and PaperRemoval of Ink Ribbon Installation of Ink RibbonFor Roll Paper Paper InsertionReplace the Printer Cover Roll Paper Removal Validation Option InstallationControl Codes ESC F Code ESC @ 1BH 40H Printer initialization ESC P Remarks Character Code List General Specifications Input Output AC 100 240 DC 12.0 V± 5% 47Hz 63 Hz Roll Paper and Print Area External Dimensions Printer Interface Circuit Interface SpecificationsDIP-SW2 Setting of the DIP SwitchesError Condition Alarm Mode Connectors and SignalsInterface Connections Cable Connection Peripheral Unit Drive CircuitPeripheral Drive Circuit Control CodesInterface for Model DP8340RD D-SUB 25 PIN Connector Current Loop RS-232CSetting of the DIP Switches Jumper Setting Setting of JumperRemoval of the Bottom Cover CTS D-Sub 25 Pin Connector Peripheral Unit Drive Circuit Peripheral Drive Circuit DTR Mode 1 Block Machine ErrorPaper Empty ON/X-OFF Mode Parity Framing ErrorSTX-ETX Mode STX-ETX Mode Flow Diagram Character Code List Page International Character Sets When Power is Supplied by the User Other parameters may be determined by user