Star Micronics DP8340R user manual Control Codes, Peripheral Drive Circuit

Page 33

M

TYPE

ONLY

Figure 7-8. Cable Connection

7-6-2.			Peripheral Drive Circuit
			Absolute Ratings (Ta = 25˚C)
D1			Voltage Breakdown		100V

			Peak Forward Current		1A

Drive

Output

12V, MAX. 1A

Figure 7-9. Drive Circuit

Caution: Do not use external power supply with peripheral drive circuit.

7-6-3. Control Codes

Codes for Drive Circuit control are ESC BEL n1 n2, BEL and FS. Refer to the Control Codes in Chapter 5.

– 29 –

Image 33

Contents DOT Matrix Printer DP8340R Series Serial Interface Trademark acknowledgments Table of Contents RS-232C Current Loop Setting of the DIP Switches DIP-SW Model Name Notation OutlineUnpacking Unpacking and InstallationInstallation of Paper Holders Installation of Paper Holders and Re-Roll Prevention GuardHandling Notes Installation of Re-Roll PreventionPart Identification and Nomenclature Power Supply UnitPrinter Front View PrinterPart Functional Description Installation of Ink Ribbon Installation of INK Ribbon and PaperRemoval of Ink Ribbon Installation of Ink RibbonFor Roll Paper Paper InsertionReplace the Printer Cover Roll Paper Removal Validation Option InstallationControl Codes ESC F Code ESC @ 1BH 40H Printer initialization ESC P Remarks Character Code List General Specifications Input Output AC 100 240 DC 12.0 V± 5% 47Hz 63 Hz Roll Paper and Print Area External Dimensions Printer Interface Circuit Interface SpecificationsDIP-SW2 Setting of the DIP SwitchesError Condition Alarm Mode Connectors and SignalsInterface Connections Cable Connection Peripheral Unit Drive CircuitPeripheral Drive Circuit Control CodesInterface for Model DP8340RD D-SUB 25 PIN Connector Current Loop RS-232CSetting of the DIP Switches Jumper Setting Setting of JumperRemoval of the Bottom Cover CTS D-Sub 25 Pin Connector Peripheral Unit Drive Circuit Peripheral Drive Circuit DTR Mode 1 Block Machine ErrorPaper Empty ON/X-OFF Mode Parity Framing ErrorSTX-ETX Mode STX-ETX Mode Flow Diagram Character Code List Page International Character Sets When Power is Supplied by the User Other parameters may be determined by user