Xantrex Technology RS232-XPD manual Command Reference, Auxa 1 on

Operation

Command Reference

Command Reference

Table 3.7 Command Reference

Command	Description
ASTS?	Asks for the supply’s accumulated status register. The accumulated status
	register stores any bit that was entered in the status register since the
	accumulated status query command (ASTS?) was last used, regardless of
	whether the condition still exists. The accumulated status register has the
	same bits, weights, and conditions as the status register. A bit in the
	accumulated status register will be set at 1 if the corresponding bit in the
	status register has been 1 (TRUE) at any time since the register was last
	read. See “Accumulated Status, Status, and Fault Registers” on page 47.
	The ASTS? query clears the status register.
	Response: ASTS <status mask> where status mask is the decimal
	equivalent of the total bit weights for the operating conditions as listed in the
	status register.
AUXA <1/ON>,<0/OFF>	Controls the AUXA output signal level at rear panel connector J21-7. Active
	low.
	Initial value: AUXA 0
AUXA?	Asks for the present set value of the AUXA output signal.
	Response: AUXA 0 (OFF)
	AUXA 1 (ON)
AUXB <1/ON>,<0/OFF>	Controls the AUXB output signal level at rear panel connector J21-8. Active
	low.
	Initial value: AUXB 0
AUXB?	Asks for the present set value of the AUXB output signal.
	Response: AUXB 0 (OFF)
	AUXB 1 (ON)
CLR	Initializes the power supply to its power ON condition. If issued while in local
	mode, CLR will force power supply settings to register default values as in
	but these default settings will not come into effect until the power supply is
	switched to remote mode operation. The CLR commands will clear faults
	from the fault register. CLR will not reset CMODE.
CMODE <1/ON>,<0/OFF>	CMODE ON places the power supply into calibration mode for processing
	calibration commands.
	Initial value: CMODE OFF or CMODE 0
CMODE?	Asks for the power supply’s calibration mode status.
	Response: CMODE 0 (disabled)
	CMODE 1 (enabled)

40 Operating Manual for RS-232 for XPD Series Power Supply