Configuring, Modifying, and Monitoring the Unit
Setting the flow control
Ports are compliant to flow control specifications 802.3x or
You can set a port to perform flow control only if this port is in full duplex mode otherwise back- pressure is applied to control the incoming flow of data.
When the port is configured to do 802.3z flow control the switching engine sends a continuous flow of idle frames to avoid dead locks.
If the port applies
get-fctrl
The
opt.[arg #0] database type - either {runnvramall}; default : run
opt.[arg #1] port index in format <dport>;default: all
Example
| gets the port | flow control request: enable or disable | |
| opt.[arg #0] | database type - either {runnvramall}; default : run | |
| opt.[arg #1] | port number - | 1..25; default : all |
| SYS_console> |
|
|
|
|
|
|
|
|
|
The
[arg #0] database type - either {runnvramall}
[arg #1] port number - 1..25
opt.[arg #2] enter either {enabledisable}; default : enable
29