Driver Installation for Windows 2000 or Windows Me

This section must be completed before continuing with the Windows 2000, Windows Me Auto Setup on page 15

On LCD monitors, unlike

CRTs, a faster refresh rate does not improve display quality. IBM recommends using either

1024 x 768 at a refresh rate of 60Hz or 640 x 480 at a refresh rate of 60Hz.

To use the Plug and Play feature in Microsoft® Windows® 2000 or Microsoft Windows Millennium Edition(Me) files should be loaded from the IBM

Monitor CD.

1.Turn off the computer and all attached devices.

2.Ensure that the monitor is connected correctly.

3.Turn on the monitor and then the system unit. Allow the system to boot into Windows 2000 or Windows Me.

4.Open the DISPLAY PROPERTIES window by clicking START, SETTINGS,

CONTROL PANEL and then double-clicking the DISPLAY icon.

5.Click the SETTINGS tab.

6.Click the ADVANCED button.

7.Click the MONITOR tab.

8.Click the PROPERTIES button.

9.Click the DRIVER tab.

10.Open the UPGRADE DEVICE DRIVER WIZARD window by clicking on UPDATE DRIVER and then Click the NEXT button.

11.Select the “Display a list of the known drivers for this device so that I can choose a specific driver” and then Click the NEXT button.

12.Insert the Setup CD into the CD drive : and click the HAVE DISK button.

13.Click OK.

14.Ensure that the CD drive letter is selected, and then select the ‘Drivers’ folder.

15.Choose IBM ThinkVision L150/150p monitor and Click OK. The files will be copied from the CD to your hard disk drive.

16.Close all open windows and remove the CD.

17.Restart the system.

The system will automatically select the maximum refresh rate and corresponding Color Matching Profiles.

COMPL & WARR JAPANESE ITALIANO