IBM L150P manual Connecting your Monitor for Analog for L150 and L150p

Page 9

Connecting your Monitor for Analog ( for L150 and L150p)

Be sure to read the ‘Safety Information’ at the front of this User Guide before carrying out this procedure.

1.Turn off your computer and all attached devices.

2.Connect the signal cable to the video port on the back of your computer. This port might be directly attached to your computer (figure A), or it might be part of a video adapter card (figure B). The video port on your computer or video adapter card might be blue to match the blue connector on your monitor’s video cable.

3.For L150, if the power cord is not attached to the monitor, please follow

the instructions below:

a

b

a.Tilt monitor all the way forward.

b.Hold the top of the cable cover (a) and pull it off.

c.Gently lift the stand cover (b) along the top and then slide it backwards and off the stand.

d.Connect the power cord to the power port on the back of your monitor.

e.Replace the rear covers.

4.For L150p, if the power cord is not attached to the monitor, connect it to the power port on the back of the monitor.

5.Insert the plug into a properly grounded electrical outlet.

7

Image 9
Contents IBM ThinkVision L150/150p Monitor L150/150pFirst Edition June/2003 Contents Page Handling Instructions Setting up the monitorWorkplace Preparation Adjusting the Monitor PositionHeight OrientationRest Working PracticesCaring for your Monitor Screen settingsBack HandsConnecting your Monitor for Analog for L150 and L150p DVI Connecting your Monitor for DigitalSwitching on your Monitor Device Driver Installation Driver installation for Windows 95 or WindowsClick the Change Monitor Type button Monitor CD Driver Installation for Windows 2000 or Windows MeDriver Installation for Windows XP Auto Setup Auto SetupOperating System Corresponding Auto Setup procedure Auto Setup for DOS Operating System Operating system installation stepsManual Setup User control features Adjusting Your LCD MonitorIcon Control Image Setup Brightness OSD Enter Description Input SignalOSD Lock / Unlock OperationOn-screen display OSD controls Initial appearance of OSDOSD functions Manual Activates automatic image adjustmentAdjusts menu location on the screen Display modes Further InformationAddressability Refresh Rate Factory Set Display ModesProduct Disposal Power ManagementProblem Possible Suggested Action Reference Cause TroubleshootingControls Select Image SetupFrançais English Japanese Italiano Español Further Help Français English SpecificationsRançais Compl & Warr Japanese Model Type Service InformationThis section contains information on notices and trademarks Trademarks
Related manuals
Manual 33 pages 21.52 Kb