IBM L150P manual Operating System Corresponding Auto Setup procedure

Page 15

Auto Setup

Auto Setup

The Setup Utility included on the installation

CD is for displaying dot patterns. They do not replace or modify the display driver.

The Auto Setup instructions require the monitor to be warmed up for 15 minutes. This is not required for normal operation.

By pressing the Auto key, you will have direct access to Auto Adjustment.

Auto setup is not required when using digital input.

When you first use your monitor you must perform Auto Setup. This procedure sets up your monitor to process the video signals from your computer without image discoloration or smearing. After you perform Auto Setup, the settings are stored and used each time you turn on the monitor.

To optimise the displayed image a set-up utility is provided on the CD. Operation of the utility is dependent on the operating system on your computer. For correct operation locate the operating system on your computer from the table below and follow the appropriate instructions. You can choose to run AUTO SETUP for each operating system that you use. This means that if you sometimes use your monitor while running any version of Windows and sometimes also use it from within DOS (not a DOS window), you must run AUTO SETUP for both Windows and DOS. You can run versions of AUTO SETUP in any order.

ESPAÑOL DEUTSCH FRANÇAIS ENGLISH

The AUTO SETUP process only applies to the current screen mode. When a new mode is selected, repeat this section to

reset the monitor.

Operating System

Corresponding Auto Setup procedure

DOS

Auto Setup for DOS on page 14

Windows 95, WIndows 98,

Auto Setup for Windows 95, Windows 98,

Windows 2000,

Microsoft Windows NT®,

Windows NT, Windows 2000, Windows Me or

Windows XP on page 15

Windows Me or Windows XP

 

Before you begin AUTO SETUP for your computer:

1.Make sure the computer’s video mode is set in the range of the supported screen resolution shown in the Table on page 23.

You should perform AUTO SETUP for each screen mode you use.

COMPL & WARR JAPANESE ITALIANO

13

Image 15
Contents IBM ThinkVision L150/150p Monitor L150/150pFirst Edition June/2003 Contents Page Handling Instructions Setting up the monitorOrientation Adjusting the Monitor PositionWorkplace Preparation HeightRest Working PracticesHands Screen settingsCaring for your Monitor BackConnecting your Monitor for Analog for L150 and L150p DVI Connecting your Monitor for DigitalSwitching on your Monitor Device Driver Installation Driver installation for Windows 95 or WindowsClick the Change Monitor Type button Monitor CD Driver Installation for Windows 2000 or Windows MeDriver Installation for Windows XP Auto Setup Auto SetupOperating System Corresponding Auto Setup procedure Auto Setup for DOS Operating System Operating system installation stepsManual Setup Input Signal Adjusting Your LCD MonitorUser control features Icon Control Image Setup Brightness OSD Enter DescriptionOSD Lock / Unlock OperationOn-screen display OSD controls Initial appearance of OSDOSD functions Manual Activates automatic image adjustmentAdjusts menu location on the screen Display modes Further InformationAddressability Refresh Rate Factory Set Display ModesProduct Disposal Power ManagementProblem Possible Suggested Action Reference Cause TroubleshootingControls Select Image SetupFrançais English Japanese Italiano Español Further Help Français English SpecificationsRançais Compl & Warr Japanese Model Type Service InformationThis section contains information on notices and trademarks Trademarks
Related manuals
Manual 33 pages 21.52 Kb