IBM L150P manual Manual Setup

Page 18

Manual Setup

If the monitor is in standby mode (STANDBY ON), it

might automatically turn off while you are waiting for it to warm up.

Manual setup is not required when using digital input.

Normally, you can complete the setup procedure using AUTO SETUP; however, if your screen image is still distorted after you perform AUTO SETUP or the Installation CD does not run on your system, perform MANUAL SETUP.

1.Have your monitor turned on for about 15 minutes, until the monitor warms up.

2.Display the image you most frequently use on the screen then go to windows shut down mode.

3.Press the OSD Enter button at the bottom of the monitor to display the initial OSD menu.

4. Use the or button to select the Image Setup icon and press

the OSD Enter button to access.

5.Use the or button to select Clock and Phase to adjustment.

(a)"Clock" (pixel frequency) controls the number of pixels scanned by one horizontal sweep.

If the frequency is not correct, the screen shows vertical stripes and the picture does not have the correct width.

(b)"Phase" adjust the phase of the pixel clock signal. With a wrong phase adjustment the picture has horizontal disturbances in

light picture.

6.Use a select ( or ) button to manually adjust to correct and execute save go to up menu then press the Exit () button to leave OSD menu.

You have completed monitor setup.

16

Image 18
Contents L150/150p IBM ThinkVision L150/150p MonitorFirst Edition June/2003 Contents Page Setting up the monitor Handling InstructionsHeight Adjusting the Monitor PositionWorkplace Preparation OrientationWorking Practices RestBack Screen settingsCaring for your Monitor HandsConnecting your Monitor for Analog for L150 and L150p Connecting your Monitor for Digital DVISwitching on your Monitor Device Driver Installation Driver installation for Windows 95 or WindowsClick the Change Monitor Type button Driver Installation for Windows 2000 or Windows Me Monitor CDDriver Installation for Windows XP Auto Setup Auto SetupOperating System Corresponding Auto Setup procedure Auto Setup for DOS Operating system installation steps Operating SystemManual Setup Icon Control Image Setup Brightness OSD Enter Description Adjusting Your LCD MonitorUser control features Input SignalOperation OSD Lock / UnlockOn-screen display OSD controls Initial appearance of OSDOSD functions Activates automatic image adjustment ManualAdjusts menu location on the screen Further Information Display modesFactory Set Display Modes Addressability Refresh RatePower Management Product DisposalTroubleshooting Problem Possible Suggested Action Reference CauseSelect Image Setup ControlsFrançais English Japanese Italiano Español Further Help Specifications Français EnglishRançais Compl & Warr Japanese Service Information Model TypeThis section contains information on notices and trademarks Trademarks
Related manuals
Manual 33 pages 21.52 Kb