Auto Setup for Windows 95, Windows 98, Windows NT, Windows 2000, Windows Me or Windows XP
ENGLISH
If the monitor is in standby mode (STANDBY ON), it
may automatically turn off while you are waiting for it to warm up.
The size and diversity of the dot pattern varies with the
screen resolution.
To set up the monitor automatically in Windows 95, Windows 98,
Windows NT, Windows 2000, Windows Me, or Windows XP, do the following:
1.Turn on the monitor first; then the computer.
If the message CHECK SIGNAL CABLE is displayed, or if nothing is displayed, check:
•that the video interface cable is connected properly.
•the correct video adapter card is installed.
•the correct supported display mode is selected for your computer.
2.Wait approximately 15 minutes, until the monitor warms up.
3.Drag the icon bar and tool bar, if they are displayed, to the bottom of the screen.
4.Insert the User's Guide and Installation CD into the computer CD-
ROM drive.
5.Check the operating system installed on your computer and follow the instructions from the table below.
FRANÇAIS
ESPAÑOL
Operating system installation steps
Operating System | Step1 | Step2 | Step3 |
|
|
|
|
|
|
|
|
Windows 95, |
|
| Type D:\TESTPAT (change |
Windows 98, | Select | Select | |
Windows 2000, | the drive letter to match your | ||
Windows NT, | START | RUN | |
Windows Me or |
|
| D) and press ENTER |
Windows XP |
|
|
|
|
|
|
|
6.When the test pattern appears, press the Image Setup ( 
) button at the bottom of the monitor. This activates the AUTO SETUP procedure, which will optimize the display settings with the provided test patterns. The screen will momentarily turn black while auto adjustment proceeds.
7.When finished, the Auto Adjustment menu disappears and the screen returns to a normal display.
8.Press the ESC key to return to Windows.
You have completed the monitor setup for Windows. If you are using the DOS operating system, go to Auto Setup for DOS on page 14.
COMPL & WARR JAPANESE ITALIANO
15