Power on, Boot Sequence, Bios Setup Utility

B5FH-5971.book Page 27 Thursday, May 23, 2002 4:13 PM

Starting Your LifeBook Notebook

POWER ON

Suspend/Resume/Power On Button

The suspend/resume/power on switch is used to turn on your LifeBook notebook from its off state. Once you have connected your AC adapter or charged the internal Lithium ion battery, you can power on your LifeBook notebook. (See figure 2-3 on page 8 for location)

P O I N T

When you turn on your LifeBook notebook be sure you have a power source. This means that at least one bat- tery is installed and charged, or that the AC or Auto/ Airline adapter is connected and has power.

To turn on your LifeBook notebook from its off state, first set the power switch on the left-hand side of the system to the “1” position. Press the suspend/resume/on button, located above the keyboard. When you are done working you can either leave your LifeBook notebook in Suspend mode, (See Suspend Mode on page 30 for more information), or you can turn it off. (See Power Off on page 31 for more information)

C A U T I O N

Do not carry your LifeBook notebook around with the power on or subject it to shocks or vibration, as you risk damaging your notebook.

When you power on your LifeBook notebook, it will perform a Power On Self Test (POST) to check the internal parts and configuration for correct functionality. If a fault is found, your LifeBook notebook will emit an audio warning and/or an error message will be displayed. (See Power On Self Test Messages on page 80 for more information) Depending on the nature of the problem, you may be able to continue by starting the operating system or by entering the BIOS setup utility and revising the settings.

After satisfactory completion of the Power On Self Test (POST), your LifeBook notebook will load your oper- ating system.

S t a r t i n g Y o u r L i f e B o o k N o t e b o o k

P O I N T

Never turn off your LifeBook notebook during the Power On Self Test (POST) or it will cause an error message to be displayed when you turn your LifeBook notebook on the next time. (See Power On Self Test Messages on page 80 for more information)

BOOT SEQUENCE

The procedure for starting-up your Fujitsu LifeBook notebook is termed the Bootup sequence and involves your LifeBook notebook’s BIOS. When your LifeBook notebook is first turned on, the main system memory is empty, and it needs to find instructions to start up your LifeBook notebook. This information is in the BIOS program. Each time you power up or restart your Life- Book notebook, it goes through a boot sequence which displays a Fujitsu logo until your operating system is loaded. During booting, your LifeBook notebook is performing a standard boot sequence including a Power On Self Test (POST). When the boot sequence is completed without a failure and without a request for the BIOS Setup Utility, the system displays the operating system’s opening screen.

The boot sequence is executed when:

■You turn on the power to your LifeBook notebook.

■You restart your LifeBook notebook from the Windows Shut Down dialog box.

■The software initiates a system restart. Example: When you install a new application.

■You reset the system by pressing the three keys [CTRL+ALT+DEL].

BIOS SETUP UTILITY

The BIOS Setup Utility is a program that sets up the operating environment for your LifeBook notebook. Your BIOS is set at the factory for normal operating conditions, therefore there is no need to set or change the BIOS’ environment to operate your LifeBook note- book.

The BIOS Setup Utility configures:

■Device control feature parameters, such as changing I/O addresses and boot devices.

■System Data Security feature parameters, such as passwords.