Fujitsu C2010, C2111 manual PC Card Problems, Power Failures

B5FH-5971.book Page 75 Thursday, May 23, 2002 4:13 PM

		T r o u b l e s h o o t i n g
Problem	Possible Cause	Possible Solutions
You have installed a	You may have the wrong I/O	See your device documentation and software docu-
USB, parallel, or IR	address selected for your device.	mentation to determine the required I/O address.
device. Your LifeBook		Change the settings in the BIOS setup utility. (See
notebook does not		figure on page 27 for location)
recognize the device, or
	Your device and another device	Check all I/O addresses located within the BIOS
the device does not seem
	are assigned the same I/O	setup utility and any other installed hardware or
to work properly.
	address.	software to make sure there are no duplications.
	Parallel port is set to output only.	Check parallel port setting in the BIOS and set to
		bi-directional or ECP.
PC Card Problems
A card inserted in the	The card is not properly installed.	Remove and re-install the card. (See PC Cards on
PC Card slot does not		page 43 for more information)
work or is locking up the
	The card may have been installed	Close the application and restart your LifeBook
system.
	while an application was running,	notebook.
	so your LifeBook notebook is not
	aware of its installation.
	Your software may not have the	See your software documentation and activate the
	correct software driver active.	correct driver.
	You may have the wrong I/O	See your PC Card documentation to determine
	address selected for your PC Card	the required I/O address. Change the settings in
	device.	the BIOS. (See BIOS Setup Utility on page 27 for
		more information)
	Your PC Card device and another	Check all I/O addresses located within the BIOS
	device are assigned the same I/O	setup utility and any other installed hardware or
	address.	software to make sure there are no duplications.
	The card may have been	If the Unplug or Eject Hardware utility has been
	“removed” using the Unplug or	used to “remove” the PC card, the system will not
	Eject Hardware utility.	recognize the card, even if it is still present in the
		slot. Physically remove the card and reinstall it in the
		slot. If that is not successful, reboot the system.
Power Failures
You turn on your	The installed primary battery is	Check the Status Indicator Panel to determine the
LifeBook notebook and	completely discharged, there is no	presence and condition of the batteries. (See Status
nothing seems to	optional second battery installed	Indicator Panel on page 13 for more information)
happen.	or there is no Power adapter (AC	Install a charged battery or a Power adapter.
	or Auto/Airline) installed.
	The primary battery is installed	Use the Status Indicator panel to verify the presence
	but is faulty.	and condition of the batteries. (See Status Indicator
		Panel on page 13 for more information) If a battery is
		indicating a short, remove that battery and operate
		from another power source or replace that battery.
	The battery or batteries are low.	Check the Status Indicator Panel to determine the
		presence and condition of the batteries. (See Status
		Indicator Panel on page 13 for more information) Use
		a Power adapter to operate until a battery is charged
		or install a charged battery.

75