Fujitsu C2010, C2111 manual Troubleshooting Table

B5FH-5971.book Page 63 Thursday, May 23, 2002 4:13 PM

U s i n g t h e W I r e l e s s L A N

TROUBLESHOOTING

This section contains troubleshooting information, including causes and actions, for problems you may find while using this device.

Troubleshooting Table

Problem	Possible Cause		Possible Solution
An exclamation mark	A failure to	Restart the computer.
(!) or cross (x) is	recognize the device.
attached to [Intersil
	A failure in installing	Restart the computer.
PRISM Wireless LAN
PCI Card].	the driver.
Other computers are	The network has not	Check the setting for the protocol, workgroup, and sharing.
not displayed when	been set up correctly.	To check this, you need a different procedure, depending upon the
the [Network
		operating system that you use. Refer to the appropriate section of
Computer] icon is
		this chapter.
double-clicked.
	It takes time before	Perform the following steps to search for the computer.
	the network is	■	Click [Start] -> [Search] -> [Other Computers].
	searched and the
		■	Enter the computer name that you are connecting to in [Name],
	computer connected
			and click [Search].
	is displayed.
		■	Double-click the icon of the computer that has been searched.
	A failure in installing	Make sure that the driver is correctly installed.
	the driver.
	The TCP/IP protocol	Make sure that the TCP/IP protocol is installed. To check this, you
	is not installed, or,	need a different procedure, depending on the operating system that
	the IP address is not	you use. Refer to the appropriate section of this manual.
	set correctly.
	The TCP/IP protocol	If the TCP/IP protocol is installed, do the following to check the IP
	is not installed, or,	address:
	the IP address is not	1.	Windows 2000:
	set correctly.
			Click [Start] -> [Programs] -> [Accessories] -> [Command
			Prompt].
			Windows XP:
			Click [Start] -> [All Programs] -> [Accessories] -> [Command
			Prompt].
		2. Enter “IPCONFIG” command, and press [Enter].
			(If your hard disk is C drive, enter
			C:\>ipconfig)
		Check that the IP address is correctly displayed under the IP Address.
		Example:
		IP address: 10.0.1.3
		Subnet Mask: 255.255.255.0
		Default Gateway: 10.0.1.1
	No communication	Shorten the distance between computers or remove visible obstacles
	due to poor radio	between them, and retry the connection.
	signal.

63