Memory Upgrade
Module
Your Fujitsu LifeBook notebook comes with 256MB of
C A U T I O N
Do not remove any screws from the memory upgrade module compartment except the ones specifically shown in the directions for installing and removing the memory upgrade module.
INSTALLING A MEMORY UPGRADE MODULE
To install a memory upgrade module follow these steps:
W A R N I N G S
■Turn off power and remove any telephone line connections before performing the memory upgrade.
■If the computer has been used recently, it may be hot. Make sure the system has cooled off completely before changing memory.
1.Turn off power to your LifeBook notebook using the power switch, and remove any power adapter (AC or auto/airline) and telephone line connections.
2.Place your LifeBook notebook on a clean work surface.
3.Open the top cover all the way, so that it is lying flat on the work surface.
4.Using your fingernail or a small flat head screw- driver, gently pry open the screw cover located over the keyboard screw. (Figure
Figure 4-8 Lifting the screw cover
M e m o r y U p g r a d e M o d u l e
5.Using a Phillips head screwdriver, remove the screw securing the keyboard. (Figure
W A R N I N G
The memory upgrade module can be severely damaged by electrostatic discharge (ESD). Be sure you are properly grounded when handling and installing the module, and follow ESD precautions noted in the literature that accompanies the memory module.
Figure 4-9 Removing the screw
6.Push the keyboard toward the back of the system until it disengages and can be lifted freely. (Figure
Figure 4-10 Sliding the keyboard
7.Carefully pivot the front of the keyboard away from the laptop until it is lying on the display.
(Figure
Figure 4-11 Folding the keyboard back
8.Align the connector edge of the memory upgrade module, chip side up, with the connector slot in the compartment. (Figure
45