Fujitsu C2010, C2111 manual Checking the full computer name and workgroup, Sharing

B5FH-5971.book Page 57 Thursday, May 23, 2002 4:13 PM

5.Set an IP address as indicated in Table 5. Ask your network administrator to check the setting.

Item	Description
For AdHoc	Set the IP address and subnet mask:
Network	Click [Use the following IP address],
	and enter a value for [IP address] and
	[Subnet mask].
	Refer to “About IP Addresses” on
	page 27 to set an IP address and
	subnet mask.
For	Select [Obtain an IP address
Infrastructure	automatically]:
Network	For the DNS server, select [Obtain
	DNS server address automatically].
	For the IP address, DNS server, and
	default gateway, follow the network
	administrator's instructions, if any.

Table 5: Setting an IP Address

6.Click [OK]. The [Local Area Connection Properties] window appears again.

7.Click [OK]. When a message appears prompting you to restart the computer, click [Yes].

Checking the full computer name and workgroup

1.Click [Start] -> [Settings] -> [Control Panel].

2.Double-click the [System] icon. [System Properties] appears.

3.Click the [Network Identification] tab.

4.Check [Full computer name] and [Workgroup]. Ask your network administrator and check the setting.

Item	Description
Full	A name to identify the computer on
Computer	the network. You can specify any
Name	name to each computer.
	For easier identification, use the model
	name or user name.

U s i n g t h e W I r e l e s s L A N

Item		Description
Workgroup	A name for the network group:
	■	AdHoc Network: Specify the same
		name to all computers within the
		same network.
	■	Infrastructure Network: Specify a
		workgroup name to connect to.
	To change a setting, click [Properties],
	and follow the instructions on the
	screen. [System Properties] appears.

Table 6: Checking computer name and workgroup

5.Click [OK]. When a message appears prompting you to restart the computer, click [Yes].

Sharing

In this section, you set sharing of the drive, folder, and printer.

You only need to set this when you are sharing files or a printer with other computers on the network.

When you share a drive, folder, or printer, you can use them from any computer on the network.

Setting [File and Printer Sharing for Microsoft Networks]

1.Click [Start] -> [Settings] -> [Control Panel].

2.Double-click the [Network and Dial-up Connections] icon. The [Network and Dial-up Connections] windows appears.

3.Right click the [Local Area Connection], then click [Properties] from the menu that appears. [Local Area Connection Properties] appears.

P O I N T

More than one network adapter is installed in your system if more than one [Local Area Connection] entry is displayed. In this case, select the [Local Area Connec- tion] entry with [Intersil PRISM Wireless LAN PCI Card] displayed under [Device Name].

4.If [File and Printer Sharing for Microsoft Networks] is displayed in the list, make sure that it is checked. If it is not checked, check it and click [OK]. You do not have to perform the following steps. Go to the next section, entitled “Sharing Files.”

If [File and Printer Sharing for Microsoft Networks] is not found in the list, click [Install], and perform Step 5 and subsequent steps. When you click [Install], the [Select Network Component Type] window appears.

57