If your system is managed by the IBM Systems Director Management Console (SDMC), use the SDMC to replace a power supply in the server. For instructions, see Replacing a part by using the Systems Director Management Console.
Determine if you are able to perform this procedure concurrently
Attention: Two power supplies must be present in the expansion unit. If one power supply fails, the expansion unit continues to operate. If you are performing this procedure concurrently (with the power turned on), there is a time limit. From the moment the power supply is removed, the exchange of the power supply must be completed in less than 5 minutes. If you cannot replace the power supply in less than 5 minutes, the I/O drawer automatically shuts down.
Before installing or reinstalling a power supply, inspect the signal connector pins to ensure that the pins are not bent or damaged.
Attention: Bent pins damage the midplane receptacle. Be careful not to touch or damage the signal connector pins.
Read the following steps, but do not perform them yet. Then decide if you are ready (and able) to complete this repair within 5 minutes.
1.Have the replacement power supply or fan ready.
2.Remove the power supply from the expansion unit.
3.Install the fan or fans into the power supply as required for the service procedure being performed.
4.Install the power supply into the enclosure.
If your system is not managed by the HMC or SDMC, complete the following steps to replace the power supply in an expansion unit or system while the system power is turned on:
1.If you are replacing a power supply or
2.Perform the prerequisite tasks, as described in Before you begin.
3.Open the front rack door.
4.Attach the wrist strap.
Attention:
vAttach a wrist strap to an unpainted surface of your hardware to prevent electrostatic discharge (ESD) from damaging your hardware.
vWhen using a wrist strap, follow all electrical safety procedures. A wrist strap is for static control. It does not increase or decrease your risk of receiving electric shock when using or working on electrical equipment.
vIf you do not have a wrist strap, just prior to removing the product from ESD packaging and installing or replacing hardware, touch an unpainted surface of the system for a minimum of 5 seconds.
5.Optional: If you must replace a failing
b. Press the fan (A) into its connector in the assembly as shown in Figure 17 on page 18. c. Tighten the thumbscrew (D) as shown in Figure 17 on page 18.