Fujitsu P310, P301 user manual Installing and removing a board, Installing a board

Page 46

■Installing and removing a board

CAUTION

Please take note of the “Information about boards” chapter.

In the upper three slots you can install boards with a length of up to 230 mm, and in the lower slot boards with a length of up to 315 mm.

The number, position and arrangement of the board slots on the mainboard can be found in the technical manual for the mainboard. Boards may already be installed when the device is shipped.

Installing a board

1Open the casing (see "Opening the casing").

1

2Remove the screw (1).

3Remove the rear slot cover plate from the slot (2).

Do not dispose of the cover plate. For cooling, protection against fire and in order to comply with EMC regulations, you must refit the cover plate if you remove the board. The top and the lowest slot are suitable for low-profile cards with an adapter.

4 Take the new board out of its packaging.

30

Image 46

Contents Deskpower P300 Series User’s Manual Model P301 / P310 Important safety instructions Iii Before reading this manual For Safe OperationUsing this Product for High-Safety Applications Backing Up the DataMicrosoft Service Pack Introduction Conventions Used in This ManualNotational conventions Manufacturer’s notes SafetyImportant Notes Energy savingFCC Class B Compliance Statement Cleaning the keyboard and the mouse Cleaning the PCCleaning the system unit and the monitor Transporting the PCDisposal and recycling Reference to productsXii Organization of This Manual Before Reading This ManualContents Technical Data System ExpansionsXvi Chapter Unpacking and Checking the Delivery Steps for Initial SetupPreparing for Use External devicesConnecting standard keyboard Setting Up the PCConnecting the keyboard Connect the Monitor, Mouse and KeyboardConnecting a PS/2 mouse Connecting the mouseConnecting USB mouse Devices without main power switch Connecting the PC to the Mains VoltageDevices with main power switch Notch for inserting the screwdriverInitial Switch-on Software will be Installed Switching on monitor and PCInstalling the software Connecting cables Connecting External DevicesDisconnecting cables LAN Connections on the system unitSettings of the serial port Connecting external devices to the serial portConnecting external devices to the parallel port Settings of the parallel portOperation On devices without main power switch Switching On the PCOn devices with main power switch OperationSwitching Off the PC Power-on indicator Indicators on the PCHard disk indicator Floppy disk indicatorKeyboard Point Floppy Disks Working with Floppy DisksProperty and Data Protection Settings in Bios SetupAccess Protection Under Windows Anti-theft protectionBios Setup Security Functions Page Troubleshooting Tips Mains voltage supply is faulty Troubleshooting and TipsInstalling New Software Internal power supply overloadedScreen stays blank Wrong monitor has been set under Windows 2000/XP No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong RAM modules have been insertedTips PC cannot be switched off with the power buttonTime and/or Date is Not Correct Out of system resourcesPage System Expansion System Expansions Information about boardsOpening the casing Closing the casingInstalling a board Installing and removing a boardTake the new board out of its packaging Page Removing a board Page Mounting slot adapter Installing an Additional Serial PortLow-Profile boards Removing slot adapterInstalling and Removing the Hard Disk Drives Removing a hard disk driveInstalling a hard disk drive Replacing Lithium Battery Page Technical Data Deskpower P300 Electrical Data