Fujitsu P310 Low-Profile boards, Installing an Additional Serial Port, Mounting slot adapter

Page 50

■Low-Profile boards

For units with a particularly low overall height, there are so-called low-profile boards with a slot cover with a lower overall height to match the low-profile units. To also install these low-profile boards in normal board slots, you must mount a corresponding slot adapter beforehand.

2

Mounting slot adapter

Fit the slot adapter on the slot cover of the low-profile board (1) and screw it on (2).

Now you can install the low-profile board in a suitable slot like a normal board (see the chapter "Installing board").

1

Removing slot adapter

Unscrew the screw (1) and remove the slot adapter (2).

■Installing an Additional Serial Port

An additional serial interface can be installed in a rear slot cover plate like a board. The condition is

that the system board has a free internal serial port.

Connect the cable of the additional serial port to the connector on the system board.

34

Image 50

Contents Deskpower P300 Series User’s Manual Model P301 / P310 Important safety instructions Iii Before reading this manual For Safe OperationUsing this Product for High-Safety Applications Backing Up the DataMicrosoft Service Pack Notational conventions Conventions Used in This ManualIntroduction Manufacturer’s notes SafetyImportant Notes Energy savingFCC Class B Compliance Statement Cleaning the keyboard and the mouse Cleaning the PCCleaning the system unit and the monitor Transporting the PCDisposal and recycling Reference to productsXii Organization of This Manual Before Reading This ManualContents Technical Data System ExpansionsXvi Chapter Unpacking and Checking the Delivery Steps for Initial SetupPreparing for Use External devicesConnecting standard keyboard Setting Up the PCConnecting the keyboard Connect the Monitor, Mouse and KeyboardConnecting USB mouse Connecting the mouseConnecting a PS/2 mouse Devices without main power switch Connecting the PC to the Mains VoltageDevices with main power switch Notch for inserting the screwdriverInitial Switch-on Software will be Installed Switching on monitor and PCInstalling the software Disconnecting cables Connecting External DevicesConnecting cables LAN Connections on the system unitSettings of the serial port Connecting external devices to the serial portConnecting external devices to the parallel port Settings of the parallel portOperation On devices without main power switch Switching On the PCOn devices with main power switch OperationSwitching Off the PC Power-on indicator Indicators on the PCHard disk indicator Floppy disk indicatorKeyboard Point Floppy Disks Working with Floppy DisksProperty and Data Protection Settings in Bios SetupAccess Protection Under Windows Anti-theft protectionBios Setup Security Functions Page Troubleshooting Tips Mains voltage supply is faulty Troubleshooting and TipsInstalling New Software Internal power supply overloadedScreen stays blank Wrong monitor has been set under Windows 2000/XP No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong RAM modules have been insertedTips PC cannot be switched off with the power buttonTime and/or Date is Not Correct Out of system resourcesPage System Expansion System Expansions Information about boardsOpening the casing Closing the casingTake the new board out of its packaging Installing and removing a boardInstalling a board Page Removing a board Page Mounting slot adapter Installing an Additional Serial PortLow-Profile boards Removing slot adapterInstalling and Removing the Hard Disk Drives Removing a hard disk driveInstalling a hard disk drive Replacing Lithium Battery Page Technical Data Deskpower P300 Electrical Data