Fujitsu P310, P301 Initial Switch-on Software will be Installed, Switching on monitor and PC

Page 22

2

1

Plug the system unit's power cable into the system unit (1) and then into the grounded mains outlet (2).

■Initial Switch-on: Software will be Installed

If the PC is connected to a network, the network protocol is required as well as the user and server details. Contact your network administrator if you have any questions about these settings.

When you switch on your PC for the first time, the supplied software is installed and configured. You should plan some time for this, as this process must not be interrupted.

CAUTION

Once the installation has been started the PC must not be switched off!

During installation the PC may only be rebooted when you are requested to do so!

Otherwise the installation will be not be performed correctly. If a fault occurs during the installation, the contents of the hard disk must be completely restored.

You may need the licence number for Windows during the installation. This number is located on a sticker on your PC.

Switching on monitor and PC

Switch the monitor on (see the operating manual for the monitor).

Switch the PC on. To do this, follow the instructions below.

6

Image 22

Contents Deskpower P300 Series User’s Manual Model P301 / P310 Important safety instructions Iii Before reading this manual For Safe OperationUsing this Product for High-Safety Applications Backing Up the DataMicrosoft Service Pack Introduction Conventions Used in This ManualNotational conventions Manufacturer’s notes SafetyImportant Notes Energy savingFCC Class B Compliance Statement Cleaning the keyboard and the mouse Cleaning the PCCleaning the system unit and the monitor Transporting the PCDisposal and recycling Reference to productsXii Organization of This Manual Before Reading This ManualContents Technical Data System ExpansionsXvi Chapter Unpacking and Checking the Delivery Steps for Initial SetupPreparing for Use External devicesConnecting standard keyboard Setting Up the PCConnecting the keyboard Connect the Monitor, Mouse and KeyboardConnecting a PS/2 mouse Connecting the mouseConnecting USB mouse Devices without main power switch Connecting the PC to the Mains VoltageDevices with main power switch Notch for inserting the screwdriverInitial Switch-on Software will be Installed Switching on monitor and PCInstalling the software Connecting cables Connecting External DevicesDisconnecting cables LAN Connections on the system unitSettings of the serial port Connecting external devices to the serial portConnecting external devices to the parallel port Settings of the parallel portOperation On devices without main power switch Switching On the PCOn devices with main power switch OperationSwitching Off the PC Power-on indicator Indicators on the PCHard disk indicator Floppy disk indicatorKeyboard Point Floppy Disks Working with Floppy DisksProperty and Data Protection Settings in Bios SetupAccess Protection Under Windows Anti-theft protectionBios Setup Security Functions Page Troubleshooting Tips Mains voltage supply is faulty Troubleshooting and TipsInstalling New Software Internal power supply overloadedScreen stays blank Wrong monitor has been set under Windows 2000/XP No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong RAM modules have been insertedTips PC cannot be switched off with the power buttonTime and/or Date is Not Correct Out of system resourcesPage System Expansion System Expansions Information about boardsOpening the casing Closing the casingInstalling a board Installing and removing a boardTake the new board out of its packaging Page Removing a board Page Mounting slot adapter Installing an Additional Serial PortLow-Profile boards Removing slot adapterInstalling and Removing the Hard Disk Drives Removing a hard disk driveInstalling a hard disk drive Replacing Lithium Battery Page Technical Data Deskpower P300 Electrical Data