MAINTENANCE
Replacing the Fan:
Reverse the above steps (1 - 4). Make sure the fan wires and the ground wire are reattached.
Hint for pushing fan down onto pins - rub a bit of dish soap on the grommet so it will slide more easily onto the pin. Check to make sure the fan is seated properly on the pins - try to move the fan back and forth, there should be no noise, if there is check that the grommets haven't come loose.
REMOVING VALVE
If your valve requires maintenance or replace- ment, use the following instructions:
Note: Alwayscloseoffthegassupplybefore removing the valve.
3)Disconnect gas line to stove.
4)Disconnect 3/8" NPT pipe from 90o elbow on valve.
5)Disconnect the two (2) switch wires from valve.
6)Disconnect piezo wire.
7)Lift off the Cast Top and lift out the front door.
8) Carefully remove the logs, embers and rockwool.
9)Remove burner (see diagram below).
Note: Use a magnetic type screwdriver if possible.
10)Remove all 18 screws holding the burner tray assembly in place.
11)Carefully lift the burner tray assembly out.
12)To replace the burner tray assembly, simply reverse these instructions.
To remove valve from valve assembly, continue.
13)Remove two (2) thermopile wires.
14)Remove thermocouple with a 9 mm (metric) wrench.
15)Remove pilot nut with an 11 mm wrench.
16)Remove valve to orifi ce nut with a 13/16" wrench.
17)Remove inlet pipe with pipe wrench. Note orientation of 90o elbow.
18)Remove two (2) phillips head M5 screws on each side of the valve.
19)Remove valve and remove gas out 90o brass fi tting. Note orientation of fi tting.
1)If optional fan is installed, disconnect power source to stove.
2)Remove access panel.
INSTALLING
VALVE ASSEMBLY
1)To install a new valve assembly, reverse instructions for removing valve. See as- sembly steps
2)Check for leaks and manifold pressure. See Gas Pressure Test instructions.
3)To reinstall valve, reverse instructions for removing valve assembly, steps
42 | Hampton® H35 Direct Vent Freestanding Gas Stove |