Hampton Direct H35-LP1 Installation, A02-43, D02-46, C02-44, Pins on Rear Log Support, B02-56

INSTALLATION

4)Place Rear Log A)02-43 on the two pins on the rear log support.

8)Place the Left Top Log D)02-46 on the pin on Log B)02-56 and on top of the cutout on Log A)02-43.

12)Position notch in Front Right Log G)02-48 on Log F)02-47 and push the bottom right edge against the bracket on the burner tray.

A)02-43 D)02-46 A)02-43

G)02	A)02-43
-
	48

C)02-44

Pins on Rear Log Support

B)02-56

	47
F)02	-

E)02-45

Pin Cutout Notch

5) Place the Middle Left Log B)02-56 on the	9) Place Front Right Log E)02-45 on the two
two pins as shown.	pins as shown.

B)02-56

E)02-45

10) Place the lava rock in the area between

the left and right logs, leaving a space in

6) Sprinkle some lava rock just in front of B) the middle for log (F) 02-47.02-56 on the burner holes.

B)02-56

G)02-48

Side View

Bracket

The bottom right edge of Log G)02-48 must sit snugly against the bracket. (Front Log 02-45 has been removed so that the bracket can be seen.)

13)Test fi re to ensure proper light off (make sure fl ame fl ows smoothly from one end of burner to the other. If there is any fl ame hesitation, check that area for any blockage of the burner port.

lava rock

11) Place the notch in Center Log F)02-47 over Log E)02-45 and across the cutout on Log

7) Place Front Left Log C)02-44 onto the 2 A)02-43.front pins as shown.

-47	A)02-43
F)02
C)02-44
	E)02-45

		46
	-
D)0	2

B)02-56

C)02-44

	47
F)02	-

G)02	A)02-43
-
	48
	E)02-45

Notch Cutout

Hampton® H35 Direct Vent Freestanding Gas Stove 33