4.2Reading a Document in Flatbed Mode
This section explains how to read a document placed on the document bed.
WARNING: Do not lock directly at the light source during read operation.
4.2.1Reading a standard-size document
If the size of the document is smaller than the document bed, read the document using the following procedure:
①Open the document cover.
②Place the document face down on the document board. Correct any curled or folded parts of the document.
③Position the long side (in landscape mode) or the short side (in portrait mode) of the document to the left side of the document bed.
Landscape mode
|
|
|
|
|
| side |
|
|
|
| |
|
| Long | ③ |
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
Left side of the document bed
Portrait mode
|
|
|
|
|
|
| side |
|
|
|
|
|
| |
|
| Short | ③ |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Document bed
Document
④Position the left top of the document to the reference mark. If the document is not placed correctly, reading cannot be done correctly.
⑤Close the document cover slowly. If the document cover is closed too quickly, the document may move.
⑥Instruct the scanner to start scanning from the host computer. Do not press on or open the document cover during the read operation.
⑦After reading, open the document cover to remove the document.
4 – 2