Fujitsu M3093DG, M3093DE manual Chapter Troubleshooting, Check items

CHAPTER 6	TROUBLESHOOTING
	If a problem occurs, use Table 6.1 to resolve the problem.
	Table 6.1 Check items
Problem	Possible cause	Response
No power	The power switch was not	Press the power switch.
	turned on.
	The power cable was not	Connect the power cable correctly.
	connected correctly.
	——————————	Turn off the power once and make an
		attempt to turn on the power again. If the
		power is not turned on, contact your
		Fujitsu service representative.*
Read operation	The documents were not	Insert the first a few pages into the slot.
does not start.	placed on the ADF correctly.
	The ADF was not closed	Make sure that the ADF is closed com-
	completely.	pletely.
	The interface cables were not	Connect the interface cables correctly.
	connected correctly.
	RS-232C baud rate setting is	Call your Fujitsu service representative.
	not proper. (M3093DE)
	SCSI-ID setting is not	Set correct SCSI ID as explained in
	proper. (M3093DG)	Section 3.5.
	Terminator was not con-	Connect the terminator.
	nected. (M3093DG).
Pictures and	Halftone processing was not	Select a halftone mode from the host
photographs are	selected.	system.
not read cor-
	The document bed, docu-	Clean the dirty parts as explained in
rectly.
	ment holding pad, or inside	Section 5.3, “Cleaning.”
	ADF is dirty.
Characters and	Simple binarization was not	Select a binarization mode from the host
lines are not	done.	computer.
read correctly.
	Is the top end of the docu-	Read the document in Photo mode or turn
	ment displayed with the	off the white level follower.
	drop-out color or white?
	The document bed, docu-	Clean the dirty parts as explained in
	ment holding pad, or the	Section 5.3, “Cleaning.”
	inside of the ADF is dirty.

6 – 1