IBM G41/G50 manual Adjusting the image, Saving and cancelling changes, Geometry reset

Page 13

Adjusting the image

The image is already optimised for many display modes. However, the controls can be used to adjust the image to your liking. IBM recommends that the factory preset image size position and shape is used when operating with a display mode listed in Table 1.

1 2

4

6

8

3

5

7

9

Saving and cancelling changes

Your settings will be automatically saved after five seconds.

Should you wish to cancel any geometry changes that you have made, press the right hand side of Key 1 where you see the following symbol within 5 seconds of making the change.

Image size, position and shape adjustment

By using Keys 2-7 shown in the diagram above, you can adjust the size, position and shape of the screen image. The pictures show how the image is affected.

Geometry reset

To reset the image size, position and shape to the factory settings, press the left hand side of Key 1 where you see the following symbol: .

There may not be any settings for the display mode you are using and so the key may have no effect.

10

Image 13
Contents User’s Guide Trademarks First Edition SeptMexico Power Cords Contents Introduction Features of this IBM monitorFurther information Getting started Unpacking checklistUnpacking Product Records G50 General SpecificationsWorkplace preparation InstallationYour Workstation Working AreaStandard connection to a PC Connecting the MonitorPlug and Play Optimising performanceDisplay Modes Addressability Refresh Line Rate How to change display modesSaving and cancelling changes Adjusting the imageImage size, position and shape adjustment Geometry resetDisabling the controls Brightness and Contrast adjustmentPower Management IndicatorsStandby SuspendOff Disabling DDC DDC ResetWorking with your Monitor Cleaning the MonitorWorking Practices Problem Suggested action TroubleshootingSpecifications section on Further help DDC GlossaryDimensions SpecificationsCompliances SafetyEuropean Union EU Statement ErgonomicsEurope Warranties