Cisco Systems 270 Locating the Power Supply LEDs, Config mode diag power-supply, Test led

69

Table 5-1:Interpreting the System-Wide LED (see Figure 5-1)

Color	State	Indication
Yellow	blinking	System identify.
		This state is initiated by the user.
		This LED can be initiated manually by using the
		diag LED test. Refer to the Command Line
		Reference Guide for more information.
		Example:
		To run identity test on Power Supply 1:
		config mode ->diag power-supply 1 ->
		test led ->
		-> start - start flashing
		-> stop - stop flashing

Power Supply LEDs

Locating the Power Supply LEDs

The Power Supply LEDs are located in the outside of each Power Supply module, if you are facing the front of the chassis with the bezel cover removed.

Figure 5-2:Power Supply LEDs