Cisco Systems 5500 manual DC-Input Power Supply Front Panels

Page 12

Chapter 7 Maintaining the Cisco Catalyst 5500 Multiswitch Router

Replacing Hardware Components

Step 2 Turn the power switch to the OFF (0) position on the power supply you are removing (see Figure 7-9).

Step 3 Remove the two screws securing the terminal block cover and slide the cover straight off the terminal block (see Figure 7-9).

Figure 7-9 DC-Input Power Supply Front Panels

Remove

DC FAN

OUTPUT

OK

OK

FAIL

Terminal block cover

Remove

Power switch

I

0

H8767

Captive screw

Step 4 Disconnect the DC-input wires from the terminal block. Disconnect the ground wire last. Step 5 Disconnect the central office (CO) ground from the CO ground connector (Figure 7-10).

Figure 7-10 DC-Input Power Supply CO Ground

SWITCH/PROCESSOR

FAN

RESET

TX

 

 

 

PS2

 

2

 

RX

 

SLOT

 

PS1

 

 

 

 

 

LINK

 

SLOT

 

 

 

 

Enet

PCMCIA

EJECT

 

 

 

 

o

o

28649

CO ground

connector

location

Step 6 Loosen and remove the captive screws on the power supply (see Figure 7-9).

Caution Use both hands to remove and install power supplies.

Step 7 Grasp the power supply handle with one hand and place your other hand underneath as you slowly pull the power supply out of the bay (see Figure 7-11).

Cisco MGC Software Release 7 Operations, Maintenance, and Troubleshooting Guide

7-12

OL-0542-06

 

 

Image 12
Contents Maintaining the Cisco Catalyst 5500 Multiswitch Router Cisco Catalyst 5500 LEDsSupervisor Engine Module LEDs Console and Auxiliary portsEthernet Switching Module 10BaseT 24 Port LEDs SlotRoute Switch Module LEDs RSM WS-X5302 LEDsUsing the Command Line Interface to Check Status RSMAvoiding Problems When Inserting and Removing Modules Tools RequiredRemoving the Supervisor Engine Using Flash Memory Pcmcia Cards Supervisor Engine Replacing the Supervisor EngineRemoving and Replacing the Power Supply Locating the Flash Memory Card Write-Protection SwitchRemoving an AC-Input Power Supply AC-Input Power Supply Front PanelsInstalling an AC-Input Power Supply Handling an AC-Input Power SupplyRemoving a DC-Input Power Supply DC-Input Power Supply Front Panels Installing a DC-Input Power Supply 11 Handling a DC Power SupplyOL-0542-06 Removing and Replacing the Chassis Fan Assembly Removing the Fan AssemblyInstalling the Fan Assembly 13 Cisco Catalyst 5500 Chassis Fan AssemblyChecking the Installation OL-0542-06