Cisco Systems SLM2008RF manual Displaying Lacp Status, Click Port Lacp Status

Page 28

Advanced Configuration	5
Advanced Configuration
Port

STEP 3 Click Save.

Displaying LACP Status

From the Port > LACP Status window, you can see the LACP status for each port, its partner port number, and operational port key.

To display LACP status, follow these steps:

STEP 1 Click Port > LACP Status.

The following information is displayed:

•LACP Port Status—LACP Status on each interface since the device was last refreshed.

•Protocol Active—Indicates if the LACP is disabled or enabled on the interface.

•Partner Port Number—Indicates the port that is in the same LAG group.

•Operational Port Key—A channel will only be formed between ports having the same operational port key. This only applies to ports located on the same switch.

Cisco SLM2008 8-Port Gigabit Smart Switch with PD and AC Power Administration Guide

23

Image 28

Contents Administration Guide OL-19923-01 Introduction Getting to Know the Cisco SLM2008 Switch Connecting the Cisco SLM2008 SwitchSetting Up the Cisco SLM2008 Switch Advanced ConfigurationVlan Appendix a Specifications Appendix B Where to Go From Here Introduction Front Panel Front Panel, Back Panel, Side Panels,Back Panel Getting to Know the Cisco SLM2008 SwitchSide Panels Side Panels Placement Options Desktop OptionConnecting the Cisco SLM2008 Switch Wall-Mount OptionSuggested Mounting Hardware Wall Mounting TemplateConnecting the Cisco SLM2008 Switch to the Network Connecting the Cisco SLM2008 Switch Setting Up the Cisco SLM2008 Switch Launching the Web-Based Configuration UtilityLogin Window Setting Up the Cisco SLM2008 SwitchNavigating the Utility Port SystemSecurity QoS StatisticsAdmin MulticastSetup Using the Help SystemAdvanced Configuration Example with Help Example with Help ExpandedClick System System Settings Configuring System SettingsSystem Click Save Configuring Port Settings PortClick Port Port Settings Configuring Static Link Aggregation Configuring Lacp Settings Click Port Static Link AggregationClick Port Lacp Settings Displaying Lacp Status Click Port Lacp StatusConfiguring Vlan Settings Configuring Vlan Settings, Configuring Vlan Port Settings,Configuring Vlan Port Settings Click Vlan Vlan SettingsClick Vlan Vlan Port Settings Configuring 802.1X Settings SecurityAdvanced Configuration Click Security 802.1X Settings Configuring 802.1X Parameter Click Security 802.1X Parameter Configuring Static MAC Address Click Security Static MAC AddressConfiguring Management Access List Click Security Management Access ListConfiguring Storm Control Click Security Storm ControlConfiguring QoS Settings QoSClick QoS QoS Settings WRR Queue Mode QoS Mode Priority Diagram802.1p QoS Mode Default 802.1p Settings 802.1p Value Priority LevelPort-Based QoS Mode Dscp Settings Dscp Value Priority All othersConfiguring STP Settings, Displaying STP Status, Configuring STP SettingsClick STP STP Settings Advanced Configuration Click STP STP Status Displaying STP StatusSTP Bridge Overview STP Port Status StatisticsDisplaying Statistics Overview, Displaying Igmp Status, Displaying Statistics Overview Click Statistics Statistics OverviewDisplaying Igmp Status Click Statistics Igmp StatusConfiguring Igmp Settings MulticastClick Multicast Igmp Settings Admin Configuring Ping Click Admin PingConfiguring Port Mirror Click Admin Port MirrorRestoring Factory Default Click Admin Factory Default Click Restore DefaultRebooting the Switch Click Admin RebootSaving Configuration Settings Click Admin Save ConfigurationClick Admin Firmware Upgrade Upgrading the FirmwareAdvanced Configuration Specifications PoEPerformance LayerManagement Other ManagementSecurity AvailabilityStandards EnvironmentalProduct Resources SupportProduct Documentation Cisco Small BusinessWhere to Go From Here