Cisco Systems SLM2008RF manual Configuring STP Settings, Displaying STP Status

Page 46

Advanced Configuration	5
Advanced Configuration
STP

STP

This section describes configuring the STP settings.

•Configuring STP Settings, page 41

•Displaying STP Status, page 43

Configuring STP Settings

The Spanning Tree Algorithm (STA) can be used to detect and disable network loops, and to provide backup links between switches, bridges or routers. This allows the switch to interact with other bridging devices (that is, an STA-compliant switch, bridge or router) in your network to ensure that only one route exists between any two stations on the network, and provide backup links which automatically take over when a primary link goes down.

The STP > STP Settings window displays the current STP settings.

To configure the STP settings, follow these steps:

STEP 1 Click STP > STP Settings.

STEP 2 Configure the STP settings.

Cisco SLM2008 8-Port Gigabit Smart Switch with PD and AC Power Administration Guide

41

Image 46

Contents Administration Guide OL-19923-01 Setting Up the Cisco SLM2008 Switch Introduction Getting to Know the Cisco SLM2008 SwitchConnecting the Cisco SLM2008 Switch Advanced ConfigurationVlan Appendix a Specifications Appendix B Where to Go From Here Introduction Front Panel Front Panel, Back Panel, Side Panels,Back Panel Getting to Know the Cisco SLM2008 SwitchSide Panels Side Panels Placement Options Desktop OptionSuggested Mounting Hardware Connecting the Cisco SLM2008 SwitchWall-Mount Option Wall Mounting TemplateConnecting the Cisco SLM2008 Switch to the Network Connecting the Cisco SLM2008 Switch Setting Up the Cisco SLM2008 Switch Launching the Web-Based Configuration UtilityLogin Window Setting Up the Cisco SLM2008 SwitchNavigating the Utility Port SystemSecurity QoS StatisticsAdmin MulticastSetup Using the Help SystemAdvanced Configuration Example with Help Example with Help ExpandedClick System System Settings Configuring System SettingsSystem Click Save Configuring Port Settings PortClick Port Port Settings Configuring Static Link Aggregation Configuring Lacp Settings Click Port Static Link AggregationClick Port Lacp Settings Displaying Lacp Status Click Port Lacp StatusConfiguring Vlan Settings Configuring Vlan Settings, Configuring Vlan Port Settings,Configuring Vlan Port Settings Click Vlan Vlan SettingsClick Vlan Vlan Port Settings Configuring 802.1X Settings SecurityAdvanced Configuration Click Security 802.1X Settings Configuring 802.1X Parameter Click Security 802.1X Parameter Configuring Static MAC Address Click Security Static MAC AddressConfiguring Management Access List Click Security Management Access ListConfiguring Storm Control Click Security Storm ControlConfiguring QoS Settings QoSClick QoS QoS Settings WRR Queue Mode QoS Mode Priority Diagram802.1p QoS Mode Default 802.1p Settings 802.1p Value Priority LevelPort-Based QoS Mode Dscp Settings Dscp Value Priority All othersConfiguring STP Settings, Displaying STP Status, Configuring STP SettingsClick STP STP Settings Advanced Configuration Click STP STP Status Displaying STP StatusSTP Bridge Overview STP Port Status StatisticsDisplaying Statistics Overview, Displaying Igmp Status, Displaying Statistics Overview Click Statistics Statistics OverviewDisplaying Igmp Status Click Statistics Igmp StatusConfiguring Igmp Settings MulticastClick Multicast Igmp Settings Admin Configuring Ping Click Admin PingConfiguring Port Mirror Click Admin Port MirrorRestoring Factory Default Click Admin Factory Default Click Restore DefaultRebooting the Switch Click Admin RebootSaving Configuration Settings Click Admin Save ConfigurationClick Admin Firmware Upgrade Upgrading the FirmwareAdvanced Configuration Performance SpecificationsPoE LayerSecurity ManagementOther Management AvailabilityStandards EnvironmentalProduct Documentation Product ResourcesSupport Cisco Small BusinessWhere to Go From Here