Cisco Systems 3750-E, 3560-E manual Module inserted face up Module inserted face down

Chapter 2 Switch Installation

Installing Devices in the 10-Gigabit Ethernet Slots

For Catalyst 3560E-12SD switches, position the module face up to install in the upper module slot (slot 1). Position the module face down to install in the lower module slot (slot 2). See Figure 2-18and Figure 2-20. Slide the module into the opening until the back of the module faceplate is flush with the switch faceplate.

Caution Do not insert or remove an X2 transceiver module with fiber-optic cables attached. An X2 module interface might go into an error-disabled state when an X2 transceiver module is inserted or removed with fiber-optic cables connected to the module. If the interface is in an error-disabled state, you can re-enable the interface by using the shutdown and no shutdown interface configuration commands.

Figure 2-18 Installing X2 Transceiver Modules in 24- and 48-Port Switches and

Catalyst 3560E-12SD Switches

1

45 46

3750-E

47 48

47X

X2

X2-2

SERIES

50

52

158121

2

1

Module inserted face up

2

Module inserted face down

Figure 2-19 Installing X2 Transceiver Modules in Catalyst 3560E-12D Switches

1

23

X2-11

X2-12

22

24

202045

1

Module inserted facing right

Catalyst 3750-E and Catalyst 3560-E Switch Hardware Installation Guide

OL-9774-03 2-21