Chapter 2 Switch Installation
Connecting Devices to the Ethernet Ports
Figure 2-24 Installing an SFP Module in Catalyst 3560E-12SD Switches
202517
Removing an SFP Module
To remove an SFP module from a module slot, follow these steps:
Step 1 Attach an
Step 2 Disconnect the cable from the SFP module. For reattachment, note which cable connector plug is send (TX) and which is receive (RX).
Step 3 Insert a dust plug into the optical ports of the SFP module to keep the optical interfaces clean.
Step 4 If the module has a
Step 5 Grasp the SFP module, and carefully remove it from the module slot.
Step 6 Place the removed SFP module in an antistatic bag or other protective environment.
Connecting Devices to the Ethernet Ports
This section includes these topics:
•10/100/1000 Ethernet Port Connections, page
•PoE Port Connections, page
Caution Category 5e and Category 6 cables can store high levels of static electricity. Always ground the cables to a suitable and safe earth ground before connecting them to the switch or other devices.
Catalyst
|
| |
|