Chapter 3 Installing the Router
IOS Software Configuration for the Router
•Line card
•Interface cables are completely seated in their line card connectors.
•Interface cables are routed neatly through the chassis
Caution Do not overtighten the captive screws on the cards; you might strip the threads on the screw or in the insert in the component faceplate.
•Power modules are fully inserted in their bays and the ejector levers are completely closed and secured.
•Check the power module LEDs:
For a router equipped with
–The green LED labeled AC should be on. It indicates that AC power source is present and is within specified limits.
–The green LED labeled DC should be on. It indicates that the power supply is operating normally in a
For a router equipped with
–The green LED labeled INPUT OK should be on. It indicates that DC power source is present and is within specified limits.
–The green LED labeled OUTPUT OK should be on. It indicates that the PEM is operating normally in a
–The amber LED labeled MISWIRE should be off. When it is on, it indicates that the input is wired backward at the PDU input.
•Each power module fan should also be on.
At the rear of the chassis, observe the status of the two LEDs on the blower module. When the blower module is operating correctly, the left LED should should be on (green) and the right LED (red) should be off.
Listen for the blowers in the blower module; they should be running. In a noisy environment, the blower might be difficult to hear. In that case, place your hand near the exhaust vents at the top and bottom rear of the chassis to verify that the blower is operating.
| Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide |
|