Cisco Systems 12406, 12006 manual Copy slot0slot1filename startup-config

Chapter 3 Installing the Router

Using Flash Memory Cards in the RP

5 1186 May 10 2002 16:56:50 myfile2

9197156 bytes available (11381148 bytes used) Router#

Copying a Configuration File from a Flash Memory Card to RP NVRAM

To copy a configuration file from a Flash memory card in PCMCIA slot 0 or slot 1 to NVRAM, follow these steps:

Step 1 Enter the command for copying a configuration file from a Flash memory card to NVRAM. This command takes the following form:

copy [slot0:slot1:]filename startup-config

where:

[slot0: slot1:]filename Specifies the source of the configuration file to be copied (the Flash memory card in either PCMCIA

	slot 0 or slot 1) and the name of the new file.
startup-config	Specifies the destination (NVRAM) of the file to be
	copied.

To start the copy operation, enter the following command at the privileged EXEC mode prompt:

Router# copy slot0:myfile startup-config

[ok]

Router#

Step 2 Use the following command to ensure that the startup configuration file, now stored in NVRAM, becomes the default running configuration file:

Router# copy startup-config running-config

Router#

%SYS-5-CONFIG_I: Configured from memory by console Router#

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03		3-81