Cisco Systems 12406, 12006 manual Flash Memory Console Commands, Router# cd slot1

Chapter 3 Installing the Router

Using Flash Memory Cards in the RP

When you enter the reload command, the specified file (new.image) on the Flash memory card inserted in PCMCIA slot 0 is used to boot the system.

If one of the following software configuration register settings were specified in the preceding example, the system would behave accordingly:

•0x2000—If the network boot fails, the system boots a default Cisco IOS software image from a Flash memory card.

•0x0100—The system ignores the Break function.

•0x0101—The system boots the default image (the first image found) from the onboard Flash memory SIMM on the RP. This setting also tells the system that it should not reset the Break disable function, nor should it check for a default filename for booting over the network.

•0x0002—The system looks in the Flash memory SIMM on the RP for a default Cisco IOS software image.

•0x0102—The system disables the Break function and checks for a default TFTP server filename. If the network boot operation fails, the system boots from a Flash memory card.

Flash Memory Console Commands

To determine whether the present working device you are accessing is the onboard Flash SIMM on the RP or a PCMCIA Flash memory card in a slot on the RP, enter the pwd command at the privileged EXEC mode prompt on the system console as follows:

Router# pwd slot0: Router#

In this example, the present working device you are accessing is on a PCMCIA Flash memory card inserted in slot 0 of the RP.

To change from one type of Flash memory device access to another, enter the cd device-namecommand, where device-namecan be slot0:, slot1:, or bootflash:.

Sample uses of the cd command include:

Router# cd slot1:

Router# pwd

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03		3-69