Chapter
Getting Started Guide | 5 |
|
LEDs & Buttons
The LEDs on the front and back of the NSS chassis help you troubleshoot a variety of conditions on the
Power LED (Front Panel)
The Power LED can be in any of the following states, depending on the current state of the NSS:
•Solid Yellow: The NSS is powered on and the boot loader is currently running. The boot loader runs for approximately 10 seconds at the beginning of the startup of the NSS, after which the LED goes to a blinking green. This condition also occurs if the upgrade of firmware process fails (although in this case, the LED remains in a solid yellow condition until the user clicks OK from the System Details page following an unsuccessful upload. After the user clicks OK, the system reboots using the current version of the firmware.)
•Blinking Yellow: The network configuration factory defaults are being reset. When resetting the network defaults, hold down the Reset button until you see the Power LED flash yellow rapidly.
•Solid Green: The NSS is powered up and finished booting.
•Blinking Green: The NSS is either booting up or shutting down.
•Alternating Yellow & Green: The firmware update is currently in progress.
•Off: The NSS is either disconnected from a power source or has finished the shutdown process and can be safely disconnected from a power source.
Chapter 5: LEDs | 49 |