Cisco Systems NSS4000, NSS6000 manual Save the Current Configuration

Page 45

Chapter

Getting Started Guide

3

 

Step 14: Save the Current Configuration

You can save a copy of the NSS configuration that can be used should you need to restore the settings at a later time. When you save the configuration file, it saves a date-stamped version of the current configuration settings to the specified volume on the NSS. You can choose to save the current configuration settings to a specified volume on the NSS or you can save the file to a USB flash device inserted into the AUX-1 port.

NOTE: If you restore a configuration file that was saved in an older version of the NSS firmware than the current version, check the settings after you restore the file to ensure they were updated correctly.

To save the current configuration:

1.If you are saving the configuration file to a USB flash device, insert a USB flash device into the AUX-1 port on the NSS chassis.

2. From the Manager Menu, click Admin Configuration.

The Configuration Manager page appears.

3.Select the location where the backup is saved from the Stored Configuration Location drop- down menu. To save the configuration file to a USB flash device, select the AUX-1port as the location. You can then copy the configuration file from the USB flash device to another location on your network.

4.Click Update.

5.Click Save to save the configuration settings. If the configuration file does not successfully save to the specified volume, check the volume to ensure that it is not locked.

Chapter 3: Configuring the Network Storage System

43

(NSS)

 

Image 45
Contents Getting Started Guide Page Contents LEDs & Buttons About this Guide BenefitsRecommended Installation Sequence Introduction Recommended Installation Sequence Chapter Install the Disk Drives Part a Set up the HardwareSetting up the Hardware Approved Vendor List for Drives Install the Ethernet LinksInstall the Power NSS-supported UPS Product Families Chapter Part B Configure the Network Storage System NSS Configuring the Network Storage System NSS Option a Linksys One Environment Login Steps Log into the Configuration InterfaceLog into the Configuration Interface Option B Standalone Environment Login Steps Configure the Timing Settings Create a RAID Array Create a RAID Array Create a Volume Create a Volume Exporting Storage to your Network Virtualize Storage within your NetworkCreating Virtualized Storage Configure the NSS Network Identification Network Identification page appears Chapter Configure the User/Group Ranges and Home Directory Location Creating a User Profile Create any Locally Defined Users and GroupsNew User page appears Creating a Group Create a Share Chapter DFS Root Set the share to be a Microsoft DFS root Adding a DFS Shared Folder Chapter Chapter Restrictions using Microsoft DFS from the NSS Create a Snapshot for a VolumeChapter Create a Scheduled Backup for a Share Chapter Complete the Configuration Save the Current Configuration Getting Sarted Guide Windows Users Accessing the NSS Storage using CIFS/SMB Part C Instruct Your Users How to Access the NSS StorageUNIX/Linux Users Accessing Storage through NFS Windows Users Accessing the NSS Storage through FTPMac Users Accessing Storage through CIFS/SMB UNIX/Linux Users Accessing Storage through FTPMac Users Accessing Storage through FTP LEDs & Buttons Power LED Front PanelSystem LED Front Panel Reset Button Front PanelHard Disk Drive LEDs Front Panel LAN LEDs Front PanelUPS LED Back Panel USB LED Front PanelLinksys One Contact Information Support Contact Information