Cisco Systems VIP4 manual 00 E1 6B 0C 47 02

Page 27

Checking the VIP4 Installation

Specific information is displayed, as shown in the following example of a VIP4-80 with a PA-2FE port adapter; the VIP4 is installed in interface processor slot 1:

Router# show diag 1

Slot 1:

Physical slot 1, ~physical slot 0xE, logical slot 1, CBus 0

Microcode Status 0x4

Master Enable, LED, WCS Loaded

Board is analyzed

Pending I/O Status:None

EEPROM format version 1

VIP4-80 RM7000 controller, HW rev 2.01, board revision A0

Serial number:14773010 Part number:73-3143-02
Test history:0x00			RMA number:00-00-00
Flags:cisco 7000 board; 7500 compatible
EEPROM contents (hex):
0x20:01 22	02	01	00 E1 6B 12	49	0C 47 02 00	00	00 00
0x30:50 06	00	00	00 00 00 00	00	00 00 00 00	00	00 00
Slot database information:
Flags:0x4		Insertion time:0x5168 (2w1d ago)
Controller Memory Size:64 MBytes CPU SDRAM, 64 MBytes Packet
SDRAM
PA Bay 0 Information:
Fast-Ethernet PA, 1 ports, 100BaseTX-ISL
EEPROM format version 1
HW rev 1.00, Board revision A0
Serial number:03536381				Part number:73-1688-03
PA Bay 1 Information:
Dual Port Fast Ethernet (RJ45), 2 ports
EEPROM format version 4
HW rev 1.00, Board revision 04
Serial number:MIC043929WV					Part number:73-5419-03

--Boot log begin--

Cisco Internetwork Operating System Software

IOS (tm) VIP Software (SVIP-DW-M), Version 12.0(16.5)S, EARLY DEPLOYMENT

MAINTENANCE INTERIM SOFTWARE

TAC Support:http://www.cisco.com/cgi-bin/ibld/view.pl?i=support

Copyright (c) 1986-2001 by cisco Systems, Inc.

Compiled Thu 29-Mar-01 16:33 by ninahung

Image text-base:0x60010938, data-base:0x60340000

--Boot log end--

Note In the preceding command output, the line that begins with Controller Memory Size shows the amount of memory installed on the VIP4. If you plan a memory upgrade, make a note of these indicated memory values, then compare them after you upgrade memory to verify the upgrade.

Fourth Generation Versatile Interface Processor (VIP4) Installation and Configuration Guide

	OL-3673-01	27

Image 27

Contents Introduction Related Documentation ContentsWhat is the VIP4? How to Identify the VIP4 ModelVIP4 Overview Eeprom contents hex Value VIP4 Model Type Size/Speed Description LocationSpecifications Description SpecificationsVIP4 Port Adapter Overview Number Product Number Description Ports VIP4 and Port Adapter CompatibilityPA-8E Installation Prerequisites Software RequirementsProduct Number Description Number of Ports VIP Release Minimum Cisco IOS Supported Releases Hardware RequirementsMicrocode Overview Traffic ManagementAgency Approvals ROM Monitor OverviewTools and Parts Required Safety Guidelines Safety WarningsApprovals Agencies Electrical Equipment Guidelines Preventing Electrostatic Discharge Damage Telephone Wiring GuidelinesGuidelines for VIP4 Removal and Installation VIP4 Installation ProceduresVIP4 Installation Procedures Bottom ejector lever Processor module slot Module Handling Interface Processors-Vertical Orientation Shown Removing a VIP4Installing a VIP4 Step Checking the VIP4 Installation Performing a Basic ConfigurationVerifying the VIP4 Installation Insertion RemovalChecking the VIP4 Installation Using show Commands to Verify the VIP4 Status Using show Commands to Display Interface InformationRouter# show interfaces fastethernet 1/0/0 Router# show controllers fastethernet 1/0/0 Router# show controllers cbusRouter# show version 00 E1 6B 0C 47 02 VIP4 Maintenance Procedures Using the ping Command to Verify Network ConnectivityUpgrading VIP4 Microcode Router# show flash Router# copy tftpvip11-1 slot0vip11-1 Router# configure terminalRouterconfig# microcode vip4 flash slot0vip11-1 Router# copy running-config startup-configProduct Description Upgrading VIP4 MemoryLocation of CPU Memory and Packet Memory DIMMs on the VIP4 Removing Sdram DIMMsOpening the Dimm Socket Tabs Inserting the Dimm Installing Sdram DIMMsInstalling or Replacing a Port Adapter on a VIP4 Checking the VIP4 Memory UpgradeHandling a Port Adapter Single-Width Port AdapterStep Dual-Width Port AdapterLocation of VIP4 Slot Divider and Screws Removing and Installing a Dual-Width Port Adapter Documentation CD-ROM VIP4 TroubleshootingObtaining Documentation World Wide WebObtaining Technical Assistance Documentation FeedbackCisco.com Contacting TAC by Using the Cisco TAC Website Technical Assistance CenterContacting TAC by Telephone Obtaining Technical Assistance OL-3673-01