Router# show controllers cbus

Checking the VIP4 Installation

Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 1271000 bits/sec, 251 packets/sec 5 minute output rate 470000 bits/sec, 83 packets/sec 1703680 packets input, 532380667 bytes, 0 no buffer

Received 4008 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog, 0 multicast

0 input packets with dribble condition detected

566766 packets output, 260633463 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

To display hardware information about all of the interface processors in your router, including the VIP4, use the show controllers cbus command.

Following is an example of the show controllers cbus command used with a Cisco 7500 series router:

slot1:VIP4-80 RM7000, hw 2.01, sw 22.20, ccb 5800FF30, cmdq 48000088, vps 8192 software loaded from system

IOS (tm) VIP Software (SVIP-DW-M), Version 12.0(16.5)S, EARLY DEPLOYMENT MAINTENANCE INTERIM SOFTWA

ROM Monitor version 103.0

FastEthernet1/0/0, addr 0000.0c4c.8820 (bia 0000.0c4c.8820) gfreeq 48000178, lfreeq 48000208 (1536 bytes)

rxlo 4, rxhi 287, rxcurr 3, maxrxcurr 222

txq 48001A00, txacc 48001A02 (value 106), txlimit 110 FastEthernet1/1/0, addr 0000.0c4c.8828 (bia 0000.0c4c.8828)

gfreeq 48000178, lfreeq 48000210 (1536 bytes) rxlo 4, rxhi 287, rxcurr 0, maxrxcurr 0

txq 48001A08, txacc 48001A0A (value 0), txlimit 110 FastEthernet1/1/1, addr 0000.0c4c.8829 (bia 0000.0c4c.8829)

gfreeq 48000178, lfreeq 48000218 (1536 bytes) rxlo 4, rxhi 287, rxcurr 3, maxrxcurr 134

txq 48001A10, txacc 48001A12 (value 106), txlimit 110

To display hardware information about a specific interface on a VIP4 port adapter, append the type argument (fastethernet, hssi, and so forth) and the interface address argument (interface-processor-slot-number/port-adapter-slot-number/interface-port-number)to the

show controllers command.

Following is an example of the syntax for this command for the interface on a PA-2FE port adapter installed in port adapter slot 0 of a VIP4 installed in interface processor slot 1 of a Cisco 7000 series or Cisco 7500 series router:

Router# show controllers fastethernet 1/0/0

To display the configuration of the system hardware (the number of each interface processor type installed), the software version, the names and sources of configuration files, and the boot images, use the show version (or show hardware) command.

Fourth Generation Versatile Interface Processor (VIP4) Installation and Configuration Guide

	OL-3673-01	25