Cisco Systems VIP4 manual Dual-Width Port Adapter, Step

VIP4 Maintenance Procedures

Figure 10 Removing and Installing a Single-Width Port Adapter

Note: You must first remove the
VIP from the chassis before
removing a port adapter from the	A
VIP4.
Step 1
To remove the port adapter,
remove
the screw that secures the port
adapter (or blank port adapter).
(See A.)
Step 2
With the screw removed, grasp
the handle on the front of the port
adapter (or blank port adapter)
and carefully pull it out of its slot,
away from the edge connector at	B
the rear of the slot. (See A.)
Step 3
To insert the port adapter,
carefully align the port adapter
carrier between the upper and
the lower edges of the port
adapter slot. (See B.)

Step 4

Install the screw in the rear of the port adapter slot. Do not overtighten the screw. (See A.)

Step 5

Carefully slide the new port adapter into the port adapter slot until the connector on the port adapter is completely seated in the connector at the rear of the port adapter slot. (See B.)

Step 6

Reinstall the VIP motherboard in the chassis, and tighten the captive installation screw on each end of the VIP faceplate. (See C.)

Screw

			Carrier
			Upper edge
			Lower edge
			C
DC
ACFAIL
POWER	NORMAL
			Captive
			installation
	EJECT		screw
I	SLOTSLOT0	1
O	SLAVEMASTER
	SLAVE/MASTER
	CPU	HALT
	RESET
DC
ACFAIL
POWER
			ENABLE
	AUX.
	CONSOLE		ROUTE
			SWITCH
I			PROCESSOR2
O
			29327

Dual-Width Port Adapter

Dual-width port adapters occupy both port adapter slots on a VIP4. Before you can install a dual-width port adapter, you must first remove the slot divider that is located between the two port adapter slots. (See Figure 11.) Refer to Table 5 for a list of dual-width port adapters.

Fourth Generation Versatile Interface Processor (VIP4) Installation and Configuration Guide

OL-3673-01 37