Cisco Systems VIP4 manual Router# show version

Page 26

Checking the VIP4 Installation

Following is an example of the show version command used with a Cisco 7500 series router:

Router# show version

Cisco Internetwork Operating System Software

IOS (tm) RSP Software (RSP-JSV-M), Version 12.0(16.5)S, EARLY DEPLOYMENT

MAINTENANCE INTERIM SOFTWARE

TAC Support:http://www.cisco.com/cgi-bin/ibld/view.pl?i=support

Copyright (c) 1986-2001 by cisco Systems, Inc.

Compiled Thu 29-Mar-01 16:27 by ninahung

Image text-base:0x60010950, data-base:0x612A2000

ROM:System Bootstrap, Version 12.0(19991117:232605) [gautham-Rommon-120S 102], DEVELOPMENT SOFTWARE

BOOTFLASH:RSP Software (RSP-JSV-M), Version 12.0(16.5)S, EARLY DEPLOYMENT MAINTENANCE INTERIM SOFTWARE

Router uptime is 2 weeks, 1 day, 19 hours, 33 minutes

System returned to ROM by reload at 20:45:17 UTC Mon Apr 2 2001

System restarted at 16:34:31 PDT Sat Apr 7 2001

System image file is "disk1:rsp-jsv-mz.120-16.5.S"

cisco RSP8 (R7000) processor with 262144K/8216K bytes of memory.

R7000 CPU at 250Mhz, Implementation 39, Rev 1.0, 256KB L2, 2048KB L3 Cache Last reset from power-on

G.703/E1 software, Version 1.0. G.703/JT2 software, Version 1.0.

X.25 software, Version 3.0.0.

SuperLAT software (copyright 1990 by Meridian Technology Corp). Bridging software.

TN3270 Emulation software. Chassis Interface.

1 EIP controller (6 Ethernet).

1 GEIP controller (1 GigabitEthernet).

1 VIP2 controller (16 Ethernet).

4 VIP2 R5K controllers (3 FastEthernet)(24 Ethernet).

2 VIP4-80 RM7000 controllers (3 FastEthernet)(1 ATM).

46 Ethernet/IEEE 802.3 interface(s)

6 FastEthernet/IEEE 802.3 interface(s)

1 GigabitEthernet/IEEE 802.3 interface(s)

1 ATM network interface(s)

2043K bytes of non-volatile configuration memory.

20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K). 40960K bytes of ATA PCMCIA card at slot 1 (Sector size 512 bytes). 16384K bytes of Flash internal SIMM (Sector size 256K).

Slave in slot 7 is running Cisco Internetwork Operating System Software

IOS (tm) RSP Software (RSP-DW-M), Version 12.0(16.5)S, EARLY DEPLOYMENT

MAINTENANCE INTERIM SOFTWARE

TAC Support:http://www.cisco.com/cgi-bin/ibld/view.pl?i=support

Copyright (c) 1986-2001 by cisco Systems, Inc.

Compiled Thu 29-Mar-01 16:30 by ninahung

Slave:Loaded from system

Slave:cisco RSP8 (R7000) processor with 262144K bytes of memory.

Configuration register is 0x2002

To determine specific hardware configuration information about a VIP4 installed in your system (including the amount of installed CPU and packet memory), use the show diag slot command.

Fourth Generation Versatile Interface Processor (VIP4) Installation and Configuration Guide

26

OL-3673-01

 

 

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Introduction Contents Related DocumentationVIP4 Overview What is the VIP4?How to Identify the VIP4 Model Eeprom contents hex Value VIP4 Model Location Type Size/Speed DescriptionVIP4 Port Adapter Overview SpecificationsDescription Specifications VIP4 and Port Adapter Compatibility Number Product Number Description PortsPA-8E Product Number Description Number of Ports Installation PrerequisitesSoftware Requirements Traffic Management Hardware RequirementsMicrocode Overview VIP Release Minimum Cisco IOS Supported ReleasesTools and Parts Required Agency ApprovalsROM Monitor Overview Approvals Agencies Safety GuidelinesSafety Warnings Electrical Equipment Guidelines Telephone Wiring Guidelines Preventing Electrostatic Discharge DamageVIP4 Installation Procedures Guidelines for VIP4 Removal and InstallationVIP4 Installation Procedures Bottom ejector lever Processor module slot Module Removing a VIP4 Handling Interface Processors-Vertical Orientation ShownInstalling a VIP4 Step Verifying the VIP4 Installation Checking the VIP4 InstallationPerforming a Basic Configuration Removal InsertionChecking the VIP4 Installation Router# show interfaces fastethernet 1/0/0 Using show Commands to Verify the VIP4 StatusUsing show Commands to Display Interface Information Router# show controllers cbus Router# show controllers fastethernet 1/0/0Router# show version 00 E1 6B 0C 47 02 Upgrading VIP4 Microcode VIP4 Maintenance ProceduresUsing the ping Command to Verify Network Connectivity Router# show flash Router# copy running-config startup-config Router# configure terminalRouterconfig# microcode vip4 flash slot0vip11-1 Router# copy tftpvip11-1 slot0vip11-1Upgrading VIP4 Memory Product DescriptionRemoving Sdram DIMMs Location of CPU Memory and Packet Memory DIMMs on the VIP4Opening the Dimm Socket Tabs Installing Sdram DIMMs Inserting the DimmChecking the VIP4 Memory Upgrade Installing or Replacing a Port Adapter on a VIP4Single-Width Port Adapter Handling a Port AdapterDual-Width Port Adapter StepLocation of VIP4 Slot Divider and Screws Removing and Installing a Dual-Width Port Adapter World Wide Web VIP4 TroubleshootingObtaining Documentation Documentation CD-ROMCisco.com Obtaining Technical AssistanceDocumentation Feedback Contacting TAC by Telephone Contacting TAC by Using the Cisco TAC WebsiteTechnical Assistance Center Obtaining Technical Assistance OL-3673-01
Top Page Image Contents