Cisco Systems 4490 manual Removing the Inner Slide Rail

Chapter 3 Installing the Cisco Global Site Selector 4490

Installing Your Unit

2.Remove the inner slide rails from the slide rail assemblies by pressing the release latches on the sides of the slide rail assemblies (Figure 3-3).

Figure 3-3 Removing the Inner Slide Rail

3

2

1

83202

1

3

Slide rail assembly 2 Release latch

Inner slide rail

3.Place an inner slide rail at the alignment marker (labeled 1 in Figure 3-4) as indicated by the arrow on the side of the GSS 4490. Use two M4 screws to secure the inner slide rail to the GSS 4490.

Repeat this step to attach the other inner slide rail to the GSS 4490.

	Cisco Global Site Selector 4490 Hardware Installation Guide
78-15755-01		3-7