16
Start the System (continued)
Use the Setup Facility
This section provides a sample of a basic router configuration using the setup facility. The output from the setup facility varies depending on the Cisco 7100 series model you are installing. It does not contain a complete example of all possible features that can be used by the various interfaces.
Note: For information the defaults settings for the various interfaces, and procedures on how to use autoinstall or global configuration mode to configure the router, refer to Chapter 4, “Performing a Basic Startup Configuration,” in the Cisco 7100 Series VPN Router Installation and Configuration Guide.
1 Power on the router. After startup, the console screen displays a script and a system banner similar to the following. When you see this information, you have successfully booted your router.
Restricted Rights Legend
Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph
(c)of the Commercial Computer Software - Restricted Rights clause at FAR sec.
(c)(1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California
Cisco Internetwork Operating System Software
IOS (tm) EGR Software
Copyright (c)
Image
cisco 7140 (EGR) processor with 90112K/73728K bytes of memory.
R7000 CPU at 262Mhz, Implementation 39, Rev 1.0, 256KB L2, 2048KB L3 Cache 4 slot midplane, Version 0.1