For More Information

Start the System (continued)

11 Save your settings to NVRAM by selecting option 2.

[0]Go to the IOS command prompt without saving this config.

[1]Return back to the setup without saving this config.

[2]Save this configuration to nvram and exit.

Enter your selection [2]: 2

Your router is now minimally conﬁgured and ready to use. You can use the setup command if you want to modify the parameters after the initial conﬁguration. To perform more complex conﬁgurations, use the conﬁgure command.

Note: If the system does not complete each of the steps in the startup procedure, proceed to Chapter 5, “Troubleshooting the Installation,” in the Cisco 7100 Series VPN Router Installation and Conﬁguration Guide for troubleshooting recommendations and procedures.

For information on additional interface conﬁguration and speciﬁc system conﬁgurations, see the following publications:

•Cisco 7100 Series VPN Conﬁguration Guide that shipped with your router. This document contains sample conﬁgurations.

•Cisco 7100 Series VPN Router Installation and Conﬁguration Guide. This document contains detailed information on hardware installation, software setup, and troubleshooting guidelines.

•Modular conﬁguration and modular command reference publications in the Cisco IOS software conﬁguration documentation set that corresponds to the software release installed on your Cisco hardware.