Cisco Systems 7100 Series manual

Start the System (continued)

4 Enter router host name, the enable secret password, enable password, and the virtual terminal password:

Configuring global parameters:

Enter host name [Router]: sanjose

The enable secret is a password used to protect access to privileged EXEC and configuration modes. This password, after entered, becomes encrypted in the configuration.

Enter enable secret: barney

The enable password is used when you do not specify an

enable secret password, with some older software versions, and some boot images.

Enter enable password: betty

The virtual terminal password is used to protect access to the router over a network interface. Enter virtual terminal password: fred

5 Enter yes or press Return to accept SNMP management; enter no to refuse it:

Configure System Management? [yes/no]: no

Configure SNMP Network Management? [yes]: no

Note: The Simple Network Management Protocol (SNMP) is the most widely supported open standard for network management. It provides a means to access and set conﬁguration and run-time parameters of routers and communication servers. SNMP deﬁnes a set of functions that can be used to monitor and control network elements.

6 Enter yes or press Return to conﬁgure IP routing and select an interior routing protocol:

Configure IP? [yes]: yes

Configure IGRP routing? [yes]: yes

Your IGRP autonomous system number [1]: 15

Configure CLNS? [no]: no

Note: Choose which protocols to support on your interfaces. For IP-only installations, you can accept the default values for most of the questions. In most cases, you use IP routing. If you are using IP routing, you must also select an interior routing protocol. You can specify only one of two interior routing protocols to operate on your system using setup: Interior Gateway Routing Protocol (IGRP) or Routing Information Protocol (RIP).